| поискавой системы для электроныых деталей |
|
RM0312 датащи(PDF) 193 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
RM0312 датащи(HTML) 193 Page - STMicroelectronics |
|
193 / 275 page ![]() DocID022352 Rev 3 193/275 RM0312 Inter-integrated circuit (I2C) interface 200 19.7.9 Status register 2 (I2C_SR2) Address offset: 0x08 Reset value: 0x00 7 654 3210 Reserved WUFH Reserved OVR AF ARLO BERR rc_w0 rc_w0 rc_w0 rc_w0 rc_w0 Bits 7:6 Reserved Bit 5 WUFH: Wakeup from Halt 0: no wakeup from Halt mode 1: 7-bit address or header match in Halt mode (slave mode) or Halt entered when in master mode. Note: This bit is set asynchronously in slave mode (during HALT mode). It is set only if ITEVTEN = 1. – cleared by software writing 0, or by hardware when PE=0. Bit 4 Reserved Bit 3 OVR: Overrun/underrun 0: No overrun/underrun 1: Overrun or underrun – Set by hardware in slave mode when NOSTRETCH=1 and: – In reception when a new byte is received (including ACK pulse) and the DR register has not been read yet. New received byte is lost. – In transmission when a new byte should be sent and the DR register has not been written yet. The same byte is sent twice. Cleared by software writing 0, or by hardware when PE=0. Note: if the DR write occurs very close to the SCL rising edge, the sent data is unspecified and a hold timing error occurs. Bit 2 AF: Acknowledge failure. 0: No acknowledge failure 1: Acknowledge failure – Set by hardware when no acknowledge is returned. – Cleared by software writing 0, or by hardware when PE=0. Bit 1 ARLO: Arbitration lost (master mode) 0: No Arbitration lost detected 1: Arbitration lost detected Set by hardware when the interface loses the arbitration of the bus to another master. – Cleared by software writing 0, or by hardware when PE=0. After an ARLO event the interface switches back automatically to Slave mode (MSL=0). Bit 0 BERR: Bus error 0: No misplaced Start or Stop condition 1: Misplaced Start or Stop condition – Set by hardware when the interface detects a SDA rising or falling edge while SCL is high, occurring in a non-valid position during a byte transfer. – Cleared by software writing 0, or by hardware when PE=0. |
|
ссылки URL |
| Вашему бизинису помогли Аллдатащит? [ DONATE ] |
Что такое Аллдатащит | реклама | контакт | Конфиденциальность | Ссылка на техническое описание | обмен ссыками | поиск по производителю All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |