UM0432 datasheet(45/53 Pages) STMICROELECTRONICS

номер детали	UM0432

подробное описание детали	Low voltage motor control demonstration board

PDF	53 Pages

Scroll/Zoom	100%

производитель	STMICROELECTRONICS [STMicroelectronics]

домашняя страница	http://www.st.com

Logo

45 / 53 page

UM0432

Motor control operations

45/53

7.7.2

Specific jumper settings

Set-up the board as per the instructions in Section 7.4.12 (bus voltage between 9 and 28 V)

and Section 7.4.13.

Set-up the board as per Table 21.

7.7.3

LED action after power-on

Turn on the power supply. For this demonstration the power supply output voltage should be

set to 30 Vdc and the current limitation of the power supply should be set to 4 A.

After power-on, the control board LEDs should blink green and red alternatingly, signaling

that the firmware has started to run. After a while a green LED stays on indicating an "idle"

state.

7.7.4

Setting the potentiometers

Before running the motor the two potentiometers P1 and P3 must be set (see Table 22 for

the correct configuration).

7.7.5

Running the motor (LED action)

Push the Start/Stop button. After pushing the button, the LEDs toggle from green to red to

indicate the "run" state. Turn P1 in a clockwise direction. Keeping P1 fixed, turn P3 in a

clockwise direction until the motor runs.

Table 21.

PMAC SR jumper settings

Driving mode

Jumper settings

PMAC_3PH_SR

J11 open, J12 open, J13 between 2-3

J15 open, J16 open, J17 between 2-3

J18 open, J19 open, J20 between 2-3

UM0432 датащи(PDF) 45 Page - STMicroelectronics