UM0432 datasheet(22/53 Pages) STMICROELECTRONICS

22 / 53 page

Motor control operations

UM0432

22/53

7.3

Software requirements

To customize, compile and download the motor control firmware, the following software must

be installed.

●

"LV ST7MC - GUI" (included in the CD-ROM).

●

STVD7 for inDART-STX V.3.11 (also called "ST7 Toolset" downloadable from Softec’s

website: www.softecmicro.com).

●

Cosmic compiler - ST7 C compiler 16 Kbyte free version - 4.5c (downloadable from

Cosmic’s website: www.cosmic-software.com).

7.3.1

Installing the software

LV ST7MC - GUI installation

Insert the CD-ROM provided with the kit and run Setup.exe.

Third-party software installation

Follow the instructions for the related software to install and configure STVD7 for inDART-

STX and cosmic compiler.

Installation steps

Install the Cosmic compiler first. Use the default installation folder: "C:\Program

Files\COSMIC\CXST7_16Kbite". Registration is required before using the product. You

can perform this procedure at any time by running the "lmreg16k.exe" file inside

Cosmic’s installation folder. Complete the form and click on the "Register by email"

button. You will receive a license file "license.lic" that must be copied to the "license"

folder in the installation folder.

Install STVD7 for inDART-STX. During the first run of the software after installation, a

prompt should appear to configure the toolset. The toolset can be configured at any

time by clicking on Tools > Options inside STVD7. In the Options window, select the

Toolset tab, then ST7Cosmic from the pull-down menu and configure the toolset as

shown in Figure 12.

UM0432 датащи(PDF) 22 Page - STMicroelectronics