LTC6946 datasheet(13/30 Pages) LINER

13 / 30 page

LTC6946

6946fa

divide ratio. See the Applications Information section for

the relationship between R and the fREF, fPFD, fVCO and

fRF frequencies.

PHASE/FREQUENCY DETECTOR (PFD)

The phase/frequency detector (PFD), in conjunction with

the charge pump, produces source and sink current pulses

proportional to the phase difference between the outputs

of the R and N dividers. This action provides the necessary

feedback to phase-lock the loop, forcing a phase align-

ment at the PFD’s inputs. The PFD may be disabled with

the CPRST bit which prevents UP and DOWN pulses from

being produced. See Figure 3 for a simplified schematic

of the PFD.

The BST bit should be set based upon the input signal level

to prevent the reference input buffer from saturating. See

Table 2 for recommended settings and the Applications

Information section for programming examples.

Table 1. FILT[1:0] Programming

FILT[1:0]

fREF

<20MHz

2NA

20MHz to 50MHz

>50MHz

Table 2. BST Programming

BST

VREF

<2.0VP-P

≥2.0VP-P

REFERENCE OUTPUT BUFFER

The reference output buffer produces a low noise square

wave with a noise floor of –155dBc/Hz (typical) at 10MHz.

Its output is low impedance, and produces 0dBm typical

output power into a 50Ω load at 10MHz. Larger output

swings will result if driving larger impedances. The out-

put is self-biased, and must be AC-coupled with a 22nF

capacitor (see Figure 2 for a simplified schematic). The

buffer may be powered down by using bit PDREFO found

in the serial port Power register h02.

REFO

VREFO

800Ω

6946 F02

Figure 2. Simplified REFO Interface Schematic

OPERATION

RST

N DIV

RST

CPRST

DOWN

6946 F03

DELAY

R DIV

Figure 3. Simplified PFD Schematic

REFERENCE (R) DIVIDER

A 10-bit divider, R_DIV, is used to reduce the frequency

seen at the PFD. Its divide ratio R may be set to any

integer from 1 to 1023, inclusive. Use the RD[9:0] bits

found in registers h03 and h04 to directly program the R

LOCK INDICATOR

The lock indicator uses internal signals from the PFD to

measure phase coincidence between the R and N divider

output signals. It is enabled by setting the LKEN bit in

the serial port register h07, and produces both LOCK and

UNLOCK status flags, available through both the STAT

output and serial port register h00.

The user sets the phase difference lock window time,

tLWW, for a valid LOCK condition with the LKWIN[1:0] bits.

See Table 3 for recommended settings for different FPFD

frequencies and the Applications Information section for

examples.

LTC6946 датащи(PDF) 13 Page - Linear Technology

LTC6946 датащи(HTML) 13 Page - Linear Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30

датащи скачать

ссылки URL