CS4298 datasheet(44/52 Pages) CIRRUS

44 / 52 page

CS4298

DS315PP2

XTL_OUT - Crystal Output

This pin is used for a crystal placed between this pin and XLT_IN. If an external clock is used

on XTL_IN or the codec is in BIT_CLK mode, this pin must be left floating with no traces or

components connected to it.

ID1#, ID0# - Codec ID, Inputs

These pins select the codec ID and mode of operation for the CS4298. They are sampled after

the rising edge of RESET# and not used after. These inputs have internal 100 k

Ω pull-ups and

should be left floating for a logic 0 or tied to analog ground for a logic 1. The pins utilize

inverted logic, so the condition of both pins floating sets the codec to primary mode while any

other combination sets the codec to a secondary mode. In primary mode, the codec is always

clocked from an external crystal or an external oscillator connected to the XTL_IN and/or

XTL_OUT pins with BIT_CLK as an output. In secondary mode, the clocking mechanism is

determined by the state of the BCM# pin with BIT_CLK always being an input.

BCM# - BIT_CLK Mode, Input

This pin selects the secondary mode clocking mechanism. BCM# is sampled after the rising

edge of RESET# and not used after. In codec secondary mode (ID1# and or ID0# grounded),

grounding this input will select BIT_CLK mode. In this mode, BIT_CLK is defined as an input

and all internal timing will be derived from the BIT_CLK signal and no connections should be

made to XTAL_IN and XTAL_OUT. When BCM# is floating, all timing will be derived from

the XTAL_IN pin. In this case, XTAL_IN must be syncronous to BIT_CLK. In primary mode,

BCM# must be left floating.

S/PDIF_OUT - Sony/Phillips Digital Interface, Output

This pin generates IEC 958 consumer compatible (S/PDIF) digital output from the CS4298

using output slots 6 and 9 when the SPDIF_EN bit in register 68h is set. For use with consumer

audio equipment, the output may be used to drive an RS422A compliant interface through an

isolation transformer, or a CP-1201 compliant interface through a TOSLINK module. When

S/PDIF_OUT is not being used this output is driven to a logic ‘0’.

GPIO[9:0] - General Purpose Input/Output

These GPIO pins are used to control modem DAAs and other discrete digital functions. When a

GPIO pin is configured as an input, it behaves as a Schmitt trigger input with 350 mV of

hysteresis at 5 V and 220 mV of hysteresis at 3.3 V. When a GPIO pin in configured as an

output, it may function as a normal CMOS output (4 mA drive) or as an open drain output.

GPIO pins power up in the high impedance state (tri-state).

CS4298 датащи(PDF) 44 Page - Cirrus Logic