AD5302/AD5312/AD5322

Rev. D | Page 8 of 24

PIN CONFIGURATION AND FUNCTION DESCRIPTIONS

GND

10

DIN

9

SCLK

8

SYNC

7

6

AD5302/

AD5312/

AD5322

TOP VIEW

(Not to Scale)

Figure 5. Pin Configuration

Table 5. Pin Function Descriptions

Pin No.

Mnemonic

Description

1

LDAC

Active Low Control Input. This pin transfers the contents of the input registers to their respective DAC registers.

Pulsing LDAC low allows either or both DAC registers to be updated if the input registers have new data. This

allows simultaneous updating of both DAC outputs.

2

Power Supply Input. The parts can be operated from 2.5 V to 5.5 V, and the supply should be decoupled to GND.

3

Reference Input Pin for DAC B. This is the reference for DAC B. It can be configured as a buffered or an

4

Reference Input Pin for DAC A. This is the reference for DAC A. It can be configured as a buffered or an

5

Buffered Analog Output Voltage from DAC A. The output amplifier has rail-to-rail operation.

6

Buffered Analog Output Voltage from DAC B. The output amplifier has rail-to-rail operation.

7

SYNC

Active Low Control Input. This is the frame synchronization signal for the input data. When SYNC goes low, it

powers on the SCLK and DIN buffers and enables the input shift register. Data is transferred in on the falling

edges of the following 16 clocks. If SYNC is taken high before the 16th falling edge, the rising edge of SYNC acts

as an interrupt and the write sequence is ignored by the device.

8

SCLK

Serial Clock Input. Data is clocked into the input shift register on the falling edge of the serial clock input. Data

can be transferred at rates up to 30 MHz. The SCLK input buffer is powered down after each write cycle.

9

DIN

Serial Data Input. This device has a 16-bit input shift register. Data is clocked into the register on the falling

edge of the serial clock input. The DIN input buffer is powered down after each write cycle.

10

GND

Ground Reference Point for All Circuitry on the Part.