PIC24FJ256GA110_10 datasheet(65/330 Pages) MICROCHIP

65 / 330 page

 2010 Microchip Technology Inc.

DS39905E-page 65

PIC24FJ256GA110 FAMILY

6.0

RESETS

The Reset module combines all Reset sources and

controls the device Master Reset Signal, SYSRST. The

following is a list of device Reset sources:

• POR: Power-on Reset

•MCLR: Pin Reset

•SWR: RESET Instruction

• WDT: Watchdog Timer Reset

• BOR: Brown-out Reset

• CM: Configuration Mismatch Reset

• TRAPR: Trap Conflict Reset

• IOPUWR: Illegal Opcode Reset

• UWR: Uninitialized W Register Reset

A simplified block diagram of the Reset module is

shown in Figure 6-1.

Any active source of Reset will make the SYSRST

signal active. Many registers associated with the CPU

and peripherals are forced to a known Reset state.

Most registers are unaffected by a Reset; their status is

unknown on POR and unchanged by all other Resets.

All types of device Reset will set a corresponding status

bit in the RCON register to indicate the type of Reset

(see Register 6-1). A Power-on Reset will clear all bits

except for the BOR and POR bits (RCON<1:0>) which

are set. The user may set or clear any bit at any time

during code execution. The RCON bits only serve as

status bits. Setting a particular Reset status bit in

software will not cause a device Reset to occur.

The RCON register also has other bits associated with

the Watchdog Timer and device power-saving states.

The function of these bits is discussed in other sections

of this data sheet.

FIGURE 6-1:

RESET SYSTEM BLOCK DIAGRAM

Note:

This data sheet summarizes the features of

this group of PIC24F devices. It is not

intended to be a comprehensive reference

source. For more information, refer to the

“PIC24F

Family

Reference

Manual”

Section 7. “Reset”

(DS39712).

Note:

Refer to the specific peripheral or CPU

section of this manual for register Reset

states.

Note:

The status bits in the RCON register

should be cleared after they are read so

that the next RCON register value after a

device Reset will be meaningful.

MCLR

VDD

VDD Rise

Detect

POR

Sleep or Idle

Brown-out

Reset

Enable Voltage Regulator

RESET

Instruction

WDT

Module

Glitch Filter

BOR

Trap Conflict

Illegal Opcode

Uninitialized W Register

SYSRST

Configuration Mismatch

PIC24FJ256GA110 датащи(PDF) 65 Page - Microchip Technology

PIC24FJ256GA110 датащи(HTML) 65 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

датащи скачать

ссылки URL