S29AS016J datasheet(33/60 Pages) SPANSION

33 / 60 page

February 1, 2012 S29AS016J_00_11

S29AS016J

Data

She e t

Figure 10.1 Program Operation

Note

See Table 11.1 on page 36 for program command sequence.

10.7

Chip Erase Command Sequence

Chip erase is a six bus cycle operation. The chip erase command sequence is initiated by writing two unlock

cycles, followed by a set-up command. Two additional unlock write cycles are then followed by the chip erase

command, which in turn invokes the Embedded Erase algorithm. The device does not require the system to

preprogram prior to erase. The Embedded Erase algorithm automatically preprograms and verifies the entire

memory for an all zero data pattern prior to electrical erase. The system is not required to provide any

controls or timings during these operations. Table 11.1 on page 36 shows the address and data requirements

for the chip erase command sequence.

Any commands written to the chip during the Embedded Erase algorithm are ignored. Note that a hardware

reset during the chip erase operation immediately terminates the operation. The Chip Erase command

sequence should be reinitiated once the device has returned to reading array data, to ensure data integrity.

The system can determine the status of the erase operation by using DQ7, DQ6, DQ2, or RY/BY#. See Write

Operation Status on page 38 for information on these status bits. When the Embedded Erase algorithm is

complete, the device returns to reading array data and addresses are no longer latched.

Figure 10.2 on page 35 illustrates the algorithm for the erase operation. See Erase/Program Operations

on page 49 for parameters, and Figure 18.6 on page 50 for timing diagrams.

START

Write Program

Command Sequence

Data Poll

from System

Verify Data?

Yes

Last Address?

Yes

Programming

Completed

Increment Address

Embedded

Program

algorithm

in progress

S29AS016J датащи(PDF) 33 Page - SPANSION