AFE5808A datasheet(24/66 Pages) TI1

24 / 66 page

D15 D14 D13 D12 D11 D10 D9

SEN

SCLK

SDATA

RESET

DataLatchedOnRisingEdgeofSCLK

StartSequence

EndSequence

T0384-01

AFE5808A

SLOS729B – OCTOBER 2011 – REVISED APRIL 2012

www.ti.com

LVDS Output Interface Description

AFE5808A has LVDS output interface which supports multiple output formats. The ADC resolutions can be

configured as 12bit or 14bit as shown in the LVDS timing diagrams Figure 59. The ADCs in the AFE5808A are

running at 14bit; 2 LSBs are removed when 12-bit output is selected; and two 0s are added at LSBs when 16-bit

output is selected. Appropriate ADC resolutions can be selected for optimizing system performance-cost

effectiveness. When the devices run at 16bit mode, higher end FPGAs are required to process higher rate of

LVDS data. Corresponding register settings are listed in Table 1.

Table 1. Corresponding Register Settings

LVDS Rate

12 bit (6X DCLK)

14 bit (7X DCLK)

16 bit (8X DCLK)

Reg 3 [14:13]

Reg 4 [2:0]

010

000

Description

2 LSBs removed

N/A

2 0s added at LSBs

SERIAL REGISTER TIMING

Serial Register Write Description

Programming of different modes can be done through the serial interface formed by pins SEN (serial interface

enable), SCLK (serial interface clock), SDATA (serial interface data) and RESET. All these pins have a pull-down

resistor to GND of 100k

Ω. Serial shift of bits into the device is enabled when SEN is low. Serial data SDATA is

latched at every rising edge of SCLK when SEN is active (low). The serial data is loaded into the register at

every 24th SCLK rising edge when SEN is low. If the word length exceeds a multiple of 24 bits, the excess bits

are ignored. Data can be loaded in multiple of 24-bit words within a single active SEN pulse (there is an internal

counter that counts groups of 24 clocks after the falling edge of SEN). The interface can work with the SCLK

frequency from 20 MHz down to low speeds (few Hertz) and even with non-50% duty cycle SCLK. The data is

divided into two main portions: a register address (8 bits) and the data itself (16 bits), to load on the addressed

Figure 60. SPI Timing

Submit Documentation Feedback

Product Folder Link(s): AFE5808A

AFE5808A датащи(PDF) 24 Page - Texas Instruments

AFE5808A датащи(HTML) 24 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66

датащи скачать

ссылки URL