705-5100-F21 datasheet(2/52 Pages) MAGNETROL

2 / 52 page

57-645 Eclipse Guided Wave Radar Transmitter - PROFIBUS PA™

Read this Manual Before Installing

This manual provides information on the Enhanced

Eclipse Model 705 transmitter with PROFIBUS PA™

Output and should be used in conjunction with Eclipse

I&O manual 57-600. It is important that all instruc-

tions are read and followed carefully.

Safety Messages

The Eclipse system is designed for use in Category II,

Pollution Degree 2 installations. Follow all standard

industry procedures for servicing electrical and computer

equipment when working with or around high voltage.

Always shut off the power supply before touching any

components. Although high voltage is not present in this

system, it may be present in other systems.

Electrical components are sensitive to electrostatic dis-

charge. To prevent equipment damage, observe safety

procedures when working with electrostatic sensitive

components.

This device complies with Part 15 of the FCC rules.

Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received,

including interference that may cause undesired operation.

WARNING! Explosion hazard. Do not connect or dis-

connect designs rated Explosion proof or Non-incendive

unless power has been switched off and/or the area is

known to be non-hazardous

Low Voltage Directive

For use in Installations Category II, Pollution Degree 2.

If equipment is used in a manner not specified by the

manufacturer, protection provided by equipment may be

impaired.

Notice of Copyright and Limitations

Magnetrol and Magnetrol logotype, STI and STI logo-

type, and Eclipse are registered trademarks of Magnetrol

International.

Performance specifications are effective with date of

issue and are subject to change without notice.

Magnetrol/STI reserves the right to make changes to the

product described in this manual at any time without

notice. Magnetrol/STI makes no warranty with respect

to the accuracy of the information in this manual.

Warranty

All Magnetrol/STI electronic level and flow controls are

warranted free of defects in materials or workmanship for

one full year from the date of original factory shipment.

If returned within the warranty period; and, upon factory

inspection of the control, the cause of the claim is deter-

mined to be covered under the warranty; then,

Magnetrol/STI will repair or replace the control at no

cost to the purchaser (or owner) other than transportation.

Magnetrol/STI shall not be liable for misapplication,

labor claims, direct or consequential damage or expense

arising from the installation or use of equipment. There

are no other warranties expressed or implied, except spe-

cial written warranties covering some Magnetrol/STI

products.

Quality assurance

The quality assurance system in place at Magnetrol/STI

guarantees the highest level of quality throughout the

company. Magnetrol is committed to providing full

customer satisfaction both in quality products and

quality service.

Magnetrol’s quality assurance system is

registered to ISO 9001 affirming its

commitment to known international

quality standards providing the

strongest assurance of product/service

quality available.

705-5100-F21 датащи(PDF) 2 Page - Magnetrol International, Inc.

705-5100-F21 датащи(HTML) 2 Page - Magnetrol International, Inc.

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52

датащи скачать

ссылки URL