| поискавой системы для электроныых деталей |
|
705-5100-F21 датащи(PDF) 13 Page - Magnetrol International, Inc. |
|
|
|||||||||||||||||||||||||||||
705-5100-F21 датащи(HTML) 13 Page - Magnetrol International, Inc. |
|
13 / 52 page ![]() 13 57-645 Eclipse Guided Wave Radar Transmitter - PROFIBUS PA™ WARNING! The Model 7xD, 7xR or 7xT overfill probes should be used for Safety Shutdown/Overfill applications. All other Guided Wave Radar probes should be installed so the maximum overfill level is a minimum of 6" (150 mm) below the process connection. This may include utilizing a nozzle or spool piece to raise the probe. Consult factory to ensure proper installation. WARNING! Do not disassemble probe when in service and under pressure. 3.4.1 Installing a Coaxial Probe (Models 7xA, 7xD, 7xP, 7xR, 7xS, and 7xT) Before installing, make sure the: • Model and serial numbers on the nameplates of the Eclipse probe and transmitter are identical. • Probe has adequate room for installation and has unob- structed entry to the bottom of the vessel. The Model 7xD (High Temp./High Pressure) probe, Model 7xP (High Pressure) probe, Model 7xR (Overfill) probe, Model 7xS (Steam) probe and Model 7xT (Interface) probe require added clearance. • Process temperature, pressure, dielectric, and viscosity are within the probe specifications for the installation. • Model 7xD (High Temp./High Pressure) probes should be handled with extra care due to the ceramic spacers used throughout their length. 3.4.1.1 To install a coaxial probe: x Make sure the process connection is at least 3⁄ 4 " NPT or a flanged mounting. y Carefully place the probe into the vessel. Align the gasket on flanged installations. z Align the probe process connection with the threaded or flanged mounting on the vessel. { For threaded connections, tighten the hex nut of the probe process connection. For flanged connections, tighten flange bolts. NOTE: If the transmitter is to be installed at a later time, do not remove the protective cap from the probe. Do not use sealing com- pound or TFE tape on probe connection to transmitter as this connection is sealed by a Viton® O-ring. y x { z |
|
ссылки URL |
| Вашему бизинису помогли Аллдатащит? [ DONATE ] |
Что такое Аллдатащит | реклама | контакт | Конфиденциальность | Ссылка на техническое описание | обмен ссыками | поиск по производителю All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |