AT90PWM3 datasheet(102/361 Pages) ATMEL

102 / 361 page

102

4317J–AVR–08/10

AT90PWM2/3/2B/3B

15. 16-bit Timer/Counter1 with PWM

The 16-bit Timer/Counter unit allows accurate program execution timing (event management),

wave generation, and signal timing measurement. The main features are:

• True 16-bit Design (i.e., Allows 16-bit PWM)

• Two independent Output Compare Units

• Double Buffered Output Compare Registers

• One Input Capture Unit

• Input Capture Noise Canceler

• Clear Timer on Compare Match (Auto Reload)

• Glitch-free, Phase Correct Pulse Width Modulator (PWM)

• Variable PWM Period

• Frequency Generator

• External Event Counter

• Four independent interrupt Sources (TOV1, OCF1A, OCF1B, and ICF1)

15.1

Overview

Most register and bit references in this section are written in general form. A lower case “n”

replaces the Timer/Counter number, and a lower case “x” replaces the Output Compare unit

channel. However, when using the register or bit defines in a program, the precise form must be

used, i.e., TCNT1 for accessing Timer/Counter1 counter value and so on.

A simplified block diagram of the 16-bit Timer/Counter is shown in Figure 15-1. For the actual

placement of I/O pins, refer to “Pin Descriptions” on page 4. CPU accessible I/O Registers,

including I/O bits and I/O pins, are shown in bold. The device-specific I/O Register and bit loca-

tions are listed in the “16-bit Timer/Counter Register Description” on page 122.

The PRTIM1 bit in “Power Reduction Register” on page 42 must be written to zero to enable

Timer/Counter1 module.

AT90PWM3 датащи(PDF) 102 Page - ATMEL Corporation