SC312XDP512F0MPVR datasheet(528/1348 Pages) FREESCALE

528 / 1348 page

Chapter 12 Serial Peripheral Interface (S12SPIV4)

MC9S12XDP512 Data Sheet, Rev. 2.21

528

Freescale Semiconductor

12.4

Functional Description

The SPI module allows a duplex, synchronous, serial communication between the MCU and peripheral

devices. Software can poll the SPI status ﬂags or SPI operation can be interrupt driven.

The SPI system is enabled by setting the SPI enable (SPE) bit in SPI control register 1. While SPE is set,

the four associated SPI port pins are dedicated to the SPI function as:

•

Slave select (SS)

•

Serial clock (SCK)

•

Master out/slave in (MOSI)

•

Master in/slave out (MISO)

The main element of the SPI system is the SPI data register. The 8-bit data register in the master and the

8-bit data register in the slave are linked by the MOSI and MISO pins to form a distributed 16-bit register.

When a data transfer operation is performed, this 16-bit register is serially shifted eight bit positions by the

S-clock from the master, so data is exchanged between the master and the slave. Data written to the master

SPI data register becomes the output data for the slave, and data read from the master SPI data register after

a transfer operation is the input data from the slave.

A read of SPISR with SPTEF = 1 followed by a write to SPIDR puts data into the transmit data register.

When a transfer is complete and SPIF is cleared, received data is moved into the receive data register. This

8-bit data register acts as the SPI receive data register for reads and as the SPI transmit data register for

writes. A single SPI register address is used for reading data from the read data buffer and for writing data

to the transmit data register.

The clock phase control bit (CPHA) and a clock polarity control bit (CPOL) in the SPI control register 1

(SPICR1) select one of four possible clock formats to be used by the SPI system. The CPOL bit simply

selects a non-inverted or inverted clock. The CPHA bit is used to accommodate two fundamentally

different protocols by sampling data on odd numbered SCK edges or on even numbered SCK edges (see

Section 12.4.3, “Transmission Formats”).

The SPI can be conﬁgured to operate as a master or as a slave. When the MSTR bit in SPI control register1

is set, master mode is selected, when the MSTR bit is clear, slave mode is selected.

NOTE

A change of CPOL or MSTR bit while there is a received byte pending in

the receive shift register will destroy the received byte and must be avoided.

SC312XDP512F0MPVR датащи(PDF) 528 Page - Freescale Semiconductor, Inc