TS8GDOM40V datasheet(38/52 Pages) TRANSCEND

38 / 52 page

rra

d 4

0---P

Piiin

n IIID

E F

Fllla

h M

ullle

B ~

~ 8

Transcend Information Inc.

Ver 1.7

Sustaining an Ultra DMA Data-In Burst

An Ultra DMA Data-In burst is sustained by following the steps lettered below. The timing diagram

is shown in below: Sustained Ultra DMA Data-In Burst Timing. The timing parameters are specified in

Page 12: Ultra DMA Data Burst Timing Requirements and are described in Page 13: Ultra DMA Data

Burst Timing Descriptions.

The following steps shall occur in the order they are listed unless otherwise specifically allowed:

a) The device shall drive a data word onto D[15:00].

b) The device shall generate a DSTROBE edge to latch the new word no sooner than tDVS after changing

the state of D[15:00]. The device shall generate a DSTROBE edge no more frequently than tCYC for the

selected Ultra DMA mode. The device shall not generate two rising or two falling DSTROBE edges

more frequently than 2tcyc for the selected Ultra DMA mode.

c) The device shall not change the state of D[15:00] until at least tDVH after generating a DSTROBE edge

to latch the data.

d) The device shall repeat steps (a), (b), and (c) until the data transfer is complete or an Ultra DMA data

burst is paused, whichever occurs first.

Notes: D[15:00] and DSTROBE signals are shown at both the host and the device to emphasize that cable settling

time as well as cable propagation delay shall not allow the data signals to be considered stable at the host

until some time after they are driven by the device.

TS8GDOM40V датащи(PDF) 38 Page - Transcend Information. Inc.