| поискавой системы для электроныых деталей |
|
ATmega328P датащи(PDF) 204 Page - ATMEL Corporation |
|
|
|||||||||||||||||||||||||||||
ATmega328P датащи(HTML) 204 Page - ATMEL Corporation |
|
204 / 448 page ![]() 204 8161D–AVR–10/09 ATmega48PA/88PA/168PA/328P 20. USART in SPI Mode 20.1 Features • Full Duplex, Three-wire Synchronous Data Transfer • Master Operation • Supports all four SPI Modes of Operation (Mode 0, 1, 2, and 3) • LSB First or MSB First Data Transfer (Configurable Data Order) • Queued Operation (Double Buffered) • High Resolution Baud Rate Generator • High Speed Operation (f XCKmax = fCK/2) • Flexible Interrupt Generation 20.2 Overview The Universal Synchronous and Asynchronous serial Receiver and Transmitter (USART) can be set to a master SPI compliant mode of operation. Setting both UMSELn1:0 bits to one enables the USART in MSPIM logic. In this mode of opera- tion the SPI master control logic takes direct control over the USART resources. These resources include the transmitter and receiver shift register and buffers, and the baud rate gen- erator. The parity generator and checker, the data and clock recovery logic, and the RX and TX control logic is disabled. The USART RX and TX control logic is replaced by a common SPI transfer control logic. However, the pin control logic and interrupt generation logic is identical in both modes of operation. The I/O register locations are the same in both modes. However, some of the functionality of the control registers changes when using MSPIM. 20.3 Clock Generation The Clock Generation logic generates the base clock for the Transmitter and Receiver. For USART MSPIM mode of operation only internal clock generation (i.e. master operation) is sup- ported. The Data Direction Register for the XCKn pin (DDR_XCKn) must therefore be set to one (i.e. as output) for the USART in MSPIM to operate correctly. Preferably the DDR_XCKn should be set up before the USART in MSPIM is enabled (i.e. TXENn and RXENn bit set to one). The internal clock generation used in MSPIM mode is identical to the USART synchronous mas- ter mode. The baud rate or UBRRn setting can therefore be calculated using the same equations, see Table 20-1: |
|
ссылки URL |
| Вашему бизинису помогли Аллдатащит? [ DONATE ] |
Что такое Аллдатащит | реклама | контакт | Конфиденциальность | Ссылка на техническое описание | обмен ссыками | поиск по производителю All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |