ATmega1284P datasheet(44/380 Pages) ATMEL

44 / 380 page

8059D–AVR–11/09

ATmega1284P

8.11.5

Watchdog Timer

If the Watchdog Timer is not needed in the application, the module should be turned off. If the

Watchdog Timer is enabled, it will be enabled in all sleep modes, and hence, always consume

power. In the deeper sleep modes, this will contribute significantly to the total current consump-

tion. Refer to ”Interrupts” on page 59 for details on how to configure the Watchdog Timer.

8.11.6

Port Pins

When entering a sleep mode, all port pins should be configured to use minimum power. The

most important is then to ensure that no pins drive resistive loads. In sleep modes where both

the I/O clock (clk

I/O) and the ADC clock (clkADC) are stopped, the input buffers of the device will

be disabled. This ensures that no power is consumed by the input logic when not needed. In

some cases, the input logic is needed for detecting wake-up conditions, and it will then be

enabled. Refer to the section ”Digital Input Enable and Sleep Modes” on page 74 for details on

which pins are enabled. If the input buffer is enabled and the input signal is left floating or have

an analog signal level close to V

CC/2, the input buffer will use excessive power.

For analog input pins, the digital input buffer should be disabled at all times. An analog signal

level close to V

CC/2 on an input pin can cause significant current even in active mode. Digital

input buffers can be disabled by writing to the Digital Input Disable Registers (DIDR1 and

DIDR0). Refer to ”DIDR1 – Digital Input Disable Register 1” on page 239 and ”DIDR0 – Digital

Input Disable Register 0” on page 259 for details.

8.11.7

On-chip Debug System

If the On-chip debug system is enabled by the OCDEN Fuse and the chip enters sleep mode,

the main clock source is enabled, and hence, always consumes power. In the deeper sleep

modes, this will contribute significantly to the total current consumption.

There are three alternative ways to disable the OCD system:

• Disable the OCDEN Fuse.

• Disable the JTAGEN Fuse.

• Write one to the JTD bit in MCUCR.

ATmega1284P датащи(PDF) 44 Page - ATMEL Corporation