ATmega1284P datasheet(34/380 Pages) ATMEL

34 / 380 page

8059D–AVR–11/09

ATmega1284P

7.6

Calibrated Internal RC Oscillator

By default, the Internal RC Oscillator provides an approximate 8 MHz clock. Though voltage and

temperature dependent, this clock can be very accurately calibrated by the the user. See Table

26-1 on page 326 for more details. The device is shipped with the CKDIV8 Fuse programmed.

See ”System Clock Prescaler” on page 36 for more details.

This clock may be selected as the system clock by programming the CKSEL Fuses as shown in

Table 7-11. If selected, it will operate with no external components. During reset, hardware loads

the pre-programmed calibration value into the OSCCAL Register and thereby automatically cal-

ibrates the RC Oscillator. The accuracy of this calibration is shown as Factory calibration in

Table 26-1 on page 326.

By changing the OSCCAL register from SW, see ”OSCCAL – Oscillator Calibration Register” on

page 38, it is possible to get a higher calibration accuracy than by using the factory calibration.

The accuracy of this calibration is shown as User calibration in Table 26-1 on page 326.

When this Oscillator is used as the chip clock, the Watchdog Oscillator will still be used for the

Watchdog Timer and for the Reset Time-out. For more information on the pre-programmed cali-

bration value, see the section ”Calibration Byte” on page 294.

Notes:

1. The device is shipped with this option selected.

2. The frequency ranges are preliminary values. Actual values are TBD.

3. If 8 MHz frequency exceeds the specification of the device (depends on V

CC), the CKDIV8

Fuse can be programmed in order to divide the internal frequency by 8.

When this Oscillator is selected, start-up times are determined by the SUT Fuses as shown in

Table 7-12 on page 34.

Note:

The device is shipped with this option selected.

Table 7-11.

Internal Calibrated RC Oscillator Operating Modes

(1)(3)

Frequency Range(2) (MHz)

CKSEL3..0

7.3 - 8.1

0010

Table 7-12.

Start-up times for the Internal Calibrated RC Oscillator clock selection

Power Conditions

Start-up Time from Power-

down and Power-save

Additional Delay from

Reset (V

CC = 5.0V)

SUT1..0

BOD enabled

6 CK

14CK

Fast rising power

6 CK

14CK + 4.1 ms

Slowly rising power

6 CK

14CK + 65 ms(1)

Reserved

ATmega1284P датащи(PDF) 34 Page - ATMEL Corporation

ATmega1284P датащи(HTML) 34 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

датащи скачать

ссылки URL