ATmega325P datasheet(209/364 Pages) ATMEL

209 / 364 page

209

8023F–AVR–07/09

ATmega325P/3250P

If Auto Triggering is enabled, single conversions can be started by writing ADSC in ADCSRA to

one. ADSC can also be used to determine if a conversion is in progress. The ADSC bit will be

read as one during a conversion, independently of how the conversion was started.

21.5

Prescaling and Conversion Timing

Figure 21-3. ADC Prescaler

By default, the successive approximation circuitry requires an input clock frequency between 50

kHz and 200 kHz to get maximum resolution. If a lower resolution than 10 bits is needed, the

input clock frequency to the ADC can be higher than 200 kHz to get a higher sample rate.

The ADC module contains a prescaler, which generates an acceptable ADC clock frequency

from any CPU frequency above 100 kHz. The prescaling is set by the ADPS bits in ADCSRA.

The prescaler starts counting from the moment the ADC is switched on by setting the ADEN bit

in ADCSRA. The prescaler keeps running for as long as the ADEN bit is set, and is continuously

reset when ADEN is low.

When initiating a single ended conversion by setting the ADSC bit in ADCSRA, the conversion

starts at the following rising edge of the ADC clock cycle.

A normal conversion takes 13 ADC clock cycles. The first conversion after the ADC is switched

on (ADEN in ADCSRA is set) takes 25 ADC clock cycles in order to initialize the analog circuitry.

When the bandgap reference voltage is used as input to the ADC, it will take a certain time for

the voltage to stabilize. If not stabilized the first value read after the first conversion may be

wrong.

The actual sample-and-hold takes place 1.5 ADC clock cycles after the start of a normal conver-

sion and 13.5 ADC clock cycles after the start of an first conversion. When a conversion is

complete, the result is written to the ADC Data Registers, and ADIF is set. In Single Conversion

mode, ADSC is cleared simultaneously. The software may then set ADSC again, and a new

conversion will be initiated on the first rising ADC clock edge.

When Auto Triggering is used, the prescaler is reset when the trigger event occurs. This assures

a fixed delay from the trigger event to the start of conversion. In this mode, the sample-and-hold

takes place two ADC clock cycles after the rising edge on the trigger source signal. Three addi-

tional CPU clock cycles are used for synchronization logic. When using Differential mode, along

7-BIT ADC PRESCALER

ADC CLOCK SOURCE

ADPS0

ADPS1

ADPS2

Reset

ADEN

START

ATmega325P датащи(PDF) 209 Page - ATMEL Corporation