ATmega165 datasheet(121/336 Pages) ATMEL

121 / 336 page

121

ATmega165/V

2573G–AVR–07/09

ment) its value. The Timer/Counter is inactive when no clock source is selected. The

output from the Clock Select logic is referred to as the timer clock (clk

T2).

The double buffered Output Compare Register (OCR2A) is compared with the

Timer/Counter value at all times. The result of the compare can be used by the Wave-

form Generator to generate a PWM or variable frequency output on the Output Compare

pin (OC2A). See “Output Compare Unit” on page 122. for details. The compare match

event will also set the Compare Flag (OCF2A) which can be used to generate an Output

Compare interrupt request.

Definitions

Many register and bit references in this document are written in general form. A lower

case “n” replaces the Timer/Counter number, in this case 2. However, when using the

accessing Timer/Counter2 counter value and so on.

The definitions in Table 53 are also used extensively throughout the section.

Timer/Counter Clock

Sources

The Timer/Counter can be clocked by an internal synchronous or an external asynchro-

nous clock source. The clock source clk

T2 is by default equal to the MCU clock, clkI/O.

When the AS2 bit in the ASSR Register is written to logic one, the clock source is taken

from the Timer/Counter Oscillator connected to TOSC1 and TOSC2. For details on

asynchronous operation, see “Asynchronous Status Register – ASSR” on page 134. For

details on clock sources and prescaler, see “Timer/Counter Prescaler” on page 138.

Counter Unit

The main part of the 8-bit Timer/Counter is the programmable bi-directional counter unit.

Figure 54 shows a block diagram of the counter and its surrounding environment.

Figure 54. Counter Unit Block Diagram

Signal description (internal signals):

count

Increment or decrement TCNT2 by 1.

direction

Selects between increment and decrement.

clear

Clear TCNT2 (set all bits to zero).

clk

Timer/Counter clock.

Table 53. Definitions

BOTTOM

The counter reaches the BOTTOM when it becomes zero (0x00).

MAX

The counter reaches its MAXimum when it becomes 0xFF (decimal 255).

TOP

The counter reaches the TOP when it becomes equal to the highest

value in the count sequence. The TOP value can be assigned to be the

fixed value 0xFF (MAX) or the value stored in the OCR2A Register. The

assignment is dependent on the mode of operation.

DATA BUS

TCNTn

Control Logic

count

TOVn

(Int.Req.)

top

bottom

direction

clear

TOSC1

T/C

Oscillator

TOSC2

Prescaler

clk

I/O

clk

ATmega165 датащи(PDF) 121 Page - ATMEL Corporation

ATmega165 датащи(HTML) 121 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

датащи скачать

ссылки URL