CS2000-OTP

DS758PP1

11

5.2.2

Crystal Connections (XTI and XTO)

An external crystal may be used to generate RefClk. To accomplish this, a 20 pF fundamental mode par-

allel resonant crystal must be connected between the XTI and XTO pins as shown in Figure 6. As shown,

nothing other than the crystal and its load capacitors should be connected to XTI and XTO. Please refer

to the “AC Electrical Characteristics” on page 7 for the allowed crystal frequency range.

5.2.3

External Reference Clock (REF_CLK)

For operation with an externally generated REF_CLK signal, XTI/REF_CLK should be connected to the

reference clock source and XTO should be left unconnected or terminated through a 47 k

Ω resistor to

GND.

5.3

Frequency Reference Clock Input, CLK_IN

The frequency reference clock input (CLK_IN) is used in Hybrid PLL Mode by the Digital PLL and Fractional-

N Logic block to dynamically generate a fractional-N value for the Frequency Synthesizer (see “Hybrid An-

alog-Digital PLL” on page 9). The Digital PLL first compares the CLK_IN frequency to the PLL output. The

Fractional-N logic block then translates the desired ratio based off of CLK_IN to one based off of the internal

timing reference clock (SysClk). This allows the low-jitter timing reference clock to be used as the clock

which the Frequency Synthesizer multiplies while maintaining synchronicity with the frequency reference

clock through the Digital PLL. The allowable frequency range for CLK_IN is found in the “AC Electrical Char-

acteristics” on page 7.

5.3.1

CLK_IN Skipping Mode

CLK_IN skipping mode allows the PLL to maintain lock even when the CLK_IN signal has missing pulses

skipping mode can only be used when the CLK_IN frequency is below 80 kHz. The ClkSkipEn global pa-

rameter enables this function.

(466 ms to 1048 ms) after CLK_IN is removed (see Figure 7). This is true as long as CLK_IN does not

glitch or have an effective change in period as the clock source is removed, otherwise the PLL will inter-

passed and the PLL to immediately unlock. If the prior conditions are met while CLK_IN is removed and

parameter; See “PLL Clock Output” on page 19. If CLK_IN is re-applied after such time, the PLL will re-

XTI

XTO

40 pF

40 pF

Figure 6. External Component Requirements for Crystal Circuit