GP32SLASH2 datasheet(24/44 Pages) CLARKE

24 / 44 page

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

4. Reach under the generator and

remove the black rubber seal

located below the oil drain plug.

5. Remove the oil fill cap/dipstick.

6. Remove the other black rubber seal

located in the front of the oil drain

plug.

7. Use a spanner to remove the oil

drain plug and allow the oil to drain

completely.

8. Reinstall the oil drain plug after the

oil has drained.

9. Reinstall the 2 black rubber seals.

NOTE: NEVER dispose of used

engine oil in general rubbish or down a drain. See local authority

recycling for more information.

10. With the generator in a level position, refill the the engine with new oil. See

section Add/Check Oil on page 12.

11. Reinstall the oil dipstick and tighten it securely. Wipe clean any oil spillage and

reinstall the oil access cover.

12. Replace the maintenance cover.

TRANSPORTING THE GENERATOR

To prevent fuel spillage when transporting, be sure to perform the following:

1. Tighten the fuel cap and turn the vacuum relief valve to ‘OFF’

2. Set the engine switch to ‘OFF’.

3. Drain the fuel tank if possible, see section Draining the Fuel Tank/carburettor on

pages 22-23.

4. Keep the generator upright. NEVER place the generator on its side or upside

down - doing so will make it difficult to start next time.

WARNING: AVOID DIRECT SUNLIGHT INSIDE A VEHICLE. IF THE

GENERATOR IS LEFT IN AN ENCLOSED VEHICLE FOR MANY HOURS,

THE HIGH TEMPERATURE COULD CAUSE THE FUEL TO VAPORISE

AND RESULT IN A POSSIBLE EXPLOSION.

GP32/2 датащи(PDF) 24 Page - Clarke International