GP32SLASH2 datasheet(16/44 Pages) CLARKE

16 / 44 page

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

STARTING YOUR GENERATOR

Before starting the generator, make sure you have read and performed the steps in the

‘Generator Preparation’ section (pages 12-15) of this manual.

ALWAYS use a ground fault circuit interrupter (GFCI) in highly conductive areas such

as metal decking or steel work. GFCI’s are available in-line with some extension cables.

CAUTION: DISCONNECT ALL ELECTRICAL LOADS FROM THE GENERATOR

BEFORE ATTEMPTING TO START.

BEFORE STARTING THE GENERATOR:

1. Verify that the generator is outside on a dry, level surface. Allow at least 1m of

clearance on all sides of the generator.

2. To maximise safety, check that the generator is properly grounded (see above).

3. Check there is sufficient level of oil in the crankcase. Add oil if necessary.

4. Make sure there is sufficient level of petrol in the fuel tank. Add fuel if necessary,

see pages 13-14.

5. Make sure all electrical devices are unplugged from the generator during ignition.

Otherwise it will be difficult for the engine to start.

TO START THE GENERATOR, PERFORM THE FOLLOWING

STEPS:

1. Turn the LOW IDLE MODE switch

to the ‘OFF’ position.

NOTE: If you wish to use the Low

Idle Mode, turn the switch

to the ‘ON’ position after

the engine has warmed up

for 2 - 3 minutes.

2. Turn the MAIN SWITCH to the

‘ON’ position.

WARNING: GENERATOR EXHAUST EMISSIONS CONTAINS CARBON

MONOXIDE (CO). THIS IS A POISONOUS GAS YOU CANNOT SEE OR

SMELL. IF YOU CAN SMELL THE GENERATOR EXHAUST, YOU ARE

BREATHING IN CO GAS.

GP32/2 датащи(PDF) 16 Page - Clarke International