M50FW040 datasheet(15/41 Pages) STMICROELECTRONICS

15 / 41 page

15/41

M50FW040

Program/Erase Suspend Command. The

Pro-

gram/Erase Suspend command can be used to

pause a Program or Erase operation. One Bus

Write cycle is required to issue the Program/Erase

Suspend command and pause the Program/Erase

Controller. Once the command is issued it is nec-

essary to poll the Program/Erase Controller Status

bit to find out when the Program/Erase Controller

has paused; no other commands will be accepted

until the Program/Erase Controller has paused.

After the Program/Erase Controller has paused,

the memory will continue to output the Status Reg-

ister until another command is issued.

During the polling period between issuing the Pro-

gram/Erase Suspend command and the Program/

Erase Controller pausing it is possible for the op-

eration to complete. Once Program/Erase Control-

ler Status bit indicates that the Program/Erase

Controller is no longer active, the Program Sus-

pend Status bit or the Erase Suspend Status bit

can be used to determine if the operation has com-

pleted or is suspended. For timing on the delay be-

tween

issuing

the

Program/Erase

Suspend

command and the Program/Erase Controller

pausing see Table 12.

During Program/Erase Suspend the Read Memo-

ry Array, Read Status Register, Read Electronic

Signature and Program/Erase Resume com-

mands will be accepted by the Command Inter-

face. Additionally, if the suspended operation was

Erase then the Program command will also be ac-

cepted; only the blocks not being erased may be

read or programmed correctly.

See Figure 20., Program Suspend & Resume

Flowchart

and

Pseudo

Code,

and

Figure

22., Erase Suspend & Resume Flowchart and

Pseudo Code, for suggested flowcharts on using

the Program/Erase Suspend command.

Program/Erase Resume Command. The

Pro-

gram/Erase Resume command can be used to re-

start

the

Program/Erase

Controller

after

Program/Erase Suspend operation has paused it.

One Bus Write cycle is required to issue the Pro-

gram/Erase Resume command. Once the com-

mand is issued subsequent Bus Read operations

read the Status Register.

Table 6. Read Electronic Signature

Code

Address

Data

Manufacturer Code

00000h

20h

Device Code

00001h

2Ch

M50FW040 датащи(PDF) 15 Page - STMicroelectronics

M50FW040 датащи(HTML) 15 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41

датащи скачать

ссылки URL