TLV9302IDDFR datasheet(22/61 Pages) TI2

22 / 61 page

7.3.7 Electrical Overstress

Designers often ask questions about the capability of an operational amplifier to withstand electrical overstress

(EOS). These questions tend to focus on the device inputs, but may involve the supply voltage pins or even

the output pin. Each of these different pin functions have electrical stress limits determined by the voltage

breakdown characteristics of the particular semiconductor fabrication process and specific circuits connected to

the pin. Additionally, internal electrostatic discharge (ESD) protection is built into these circuits to protect them

from accidental ESD events both before and during product assembly.

Having a good understanding of this basic ESD circuitry and its relevance to an electrical overstress event is

helpful. Figure 7-9 shows an illustration of the ESD circuits contained in the TLV930x (indicated by the dashed

line area). The ESD protection circuitry involves several current-steering diodes connected from the input and

output pins and routed back to the internal power-supply lines, where the diodes meet at an absorption device

or the power-supply ESD cell, internal to the operational amplifier. This protection circuitry is intended to remain

inactive during normal circuit operation.

Power Supply

ESD Cell

100 Ÿ

VSS

VDD

IN±

IN+

TVS

VIN

+VS

±VS

TLV930x

Figure 7-9. Equivalent Internal ESD Circuitry Relative to a Typical Circuit Application

An ESD event is very short in duration and very high voltage (for example, 1 kV, 100 ns), whereas an EOS event

is long duration and lower voltage (for example, 50 V, 100 ms). The ESD diodes are designed for out-of-circuit

ESD protection (that is, during assembly, test, and storage of the device before being soldered to the PCB).

During an ESD event, the ESD signal is passed through the ESD steering diodes to an absorption circuit

(labeled ESD power-supply circuit). The ESD absorption circuit clamps the supplies to a safe level.

Although this behavior is necessary for out-of-circuit protection, excessive current and damage is caused if

activated in-circuit. A transient voltage suppressors (TVS) can be used to prevent against damage caused by

turning on the ESD absorption circuit during an in-circuit ESD event. Using the appropriate current limiting

resistors and TVS diodes allows for the use of device ESD diodes to protect against EOS events.

TLV9301, TLV9302, TLV9304

SBOS941D – FEBRUARY 2019 – REVISED AUGUST 2021

www.ti.com

Submit Document Feedback

Product Folder Links: TLV9301 TLV9302 TLV9304

TLV9302IDDFR датащи(PDF) 22 Page - Texas Instruments