LP55231 datasheet(18/59 Pages) TI2

18 / 59 page

SCL

SDA

data

change

allowed

data

valid

data

change

allowed

data

valid

data

change

allowed

LP55231

SNOSCR5D – MARCH 2013 – REVISED DECEMBER 2016

www.ti.com

Product Folder Links: LP55231

Submit Documentation Feedback

7.5 Programming

7.5.1 I2C-Compatible Control Interface

The I2C-compatible synchronous serial interface provides access to the programmable functions and registers on

the device. This protocol uses a two-wire interface for bidirectional communications between the ICs connected

to the bus. The two interface lines are the Serial Data Line (SDA) and the Serial Clock Line (SCL). Every device

on the bus is assigned a unique address and acts as either a Master or a Slave depending on whether it

generates or receives the serial clock SCL. The SCL and SDA lines should each have a pullup resistor placed

somewhere on the line and remain HIGH even when the bus is idle. Note: CLK pin is not used for serial bus data

transfer.

7.5.1.1 Data Validity

The data on SDA line must be stable during the HIGH period of the clock signal (SCL). In other words, state of

the data line can only be changed when clock signal is LOW.

Figure 20. Data Validity Diagram

7.5.1.2 Start And Stop Conditions

START and STOP conditions classify the beginning and the end of the data transfer session. A START condition

is defined as the SDA signal transitioning from HIGH to LOW while SCL line is HIGH. A STOP condition is

defined as the SDA transitioning from LOW to HIGH while SCL is HIGH. The bus master always generates

START and STOP conditions. The bus is considered to be busy after a START condition and free after a STOP

condition. During data transmission, the bus master can generate repeated START conditions. First START and

repeated START conditions are equivalent, function-wise.

7.5.1.3 Transferring Data

Every byte put on the SDA line must be eight bits long, with the most significant bit (MSB) being transferred first.

Each byte of data has to be followed by an acknowledge bit. The acknowledge related clock pulse is generated

by the master. The master releases the SDA line (HIGH) during the acknowledge clock pulse. The LP55231 pulls

down the SDA line during the 9th clock pulse, signifying an acknowledge. The LP55231 generates an

acknowledge after each byte has been received.

There is one exception to the acknowledge after every byte rule. When the master is the receiver, it must

indicate to the transmitter an end of data by not acknowledging (negative acknowledge) the last byte clocked out

of the slave. This negative acknowledge still includes the acknowledge clock pulse (generated by the master),

but the SDA line is not pulled down.

After the START condition, the bus master sends a chip address. This address is seven bits long followed by an

eighth bit which is a data direction bit (READ or WRITE). The LP55231 address is defined with ASEL0 and

ASEL1 pins, and it is 32h when ASEL1 and ASEL0 are connected to GND. For the eighth bit, a 0 indicates a

WRITE, and a 1 indicates a READ. The second byte selects the register to which the data is written. The third

byte contains data to write to the selected register.

LP55231 датащи(PDF) 18 Page - Texas Instruments

LP55231 датащи(HTML) 18 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59

датащи скачать

ссылки URL