EF6805P2 datasheet(15/31 Pages) STMICROELECTRONICS

номер детали	EF6805P2

подробное описание детали	8-BIT MICROCOMPUTER UNIT

PDF	31 Pages

Scroll/Zoom	100%

производитель	STMICROELECTRONICS [STMicroelectronics]

домашняя страница	http://www.st.com

Logo

15 / 31 page

Figure 18 : RESET and interrupt Processing Flowchard.

NOTE

The timer and INT2 interrupts share the same vector

address. The interrupt routine must determine the

source by examining the interrupt request bits (TCR

b7 and MR b7). Both TCR b7 and MR b7 can only

be written to zero by software.

The external interrupt, INT and INT2, are synchro-

nized and then latched on the falling edge of the in-

put signal. The INT2 interrupt has an interrupt re-

quest bit (bit 7) and a mask bit (bit 6) located in the

miscellaneous register (MR). The INT2 interrupt is

inhibited when the mask bit is set. The INT2 is al-

ways read as a digital input on port D. The INT2 and

timer interrup requests bits, if set, cause the MCU to

process an interrupt when the condition code I bit is

clear.

A sinuoidal input signal (fINT maximum) can be used

to generate an external interrupt for use as a zero-

crossing detector. This allows applications such as

servicing time-of-day routines and engaging/disen-

gaging ac power control devices. Off-chip full wave

rectification provides an interrupt at every zero cros-

sing of the ac signal and thereby provides a 2f clock.

See figure 19.

NOTE

The INT (pin 3) is internally biased at approximately

2.2V due to the internal zero-crossing detection.

EF6805U3

15/31

EF6805P2 датащи(PDF) 15 Page - STMicroelectronics