STA326 datasheet(19/64 Pages) STMICROELECTRONICS

19 / 64 page

DocID11531 Rev 9

19/64

STA326

I2C bus specification

The STA326 supports the I2C protocol. This protocol defines any device that sends data on

to the I2C bus as a transmitter and any device that reads the data as a receiver. The device

that controls the data transfer is known as the master and the other as the slave. The

master always starts the transfer and provides the serial clock for synchronization. The

STA326 is always a slave device in all of its communications.

6.1

Communication protocol

Data transition or change

Data changes on the SDA line must only occur when the SCL clock is low. SDA transition

while the clock is high is used to identify a START or STOP condition.

Start condition

START is identified by a high to low transition of the data bus SDA signal while the clock

signal SCL is stable in the high state. A START condition must precede any command for

data transfer.

Stop condition

STOP is identified by a low to high transition of the data bus SDA signal while the clock

signal SCL is stable in the high state. A STOP condition terminates communication between

STA326 and the bus master.

Data input

During the data input the STA326 samples the SDA signal on the rising edge of clock SCL.

For correct device operation the SDA signal must be stable during the rising edge of the

clock and the data can change only when the SCL line is low.

6.2

Device addressing

To start communication between the master and the STA326, the master must initiate with a

start condition. Following this, the master sends 8 bits (MSB first) onto the SDA line

corresponding to the device select address and read or write mode.

The 7 MSBs are the device address identifiers, corresponding to the I2C bus definition. The

STA326 device address is 0x34.

The 8th bit (LSB) identifies read or write operation, RW. This bit is set to 1 in read mode and

0 for write mode. After a START condition the STA326 identifies the device address on the

bus. If a match is found, it acknowledges the identification on the SDA bus during the 9th bit

time. The byte following the device identification byte is the internal space address.

Obsolete

Product(s)

- Obsolete

Product(s)

STA326 датащи(PDF) 19 Page - STMicroelectronics