STM32WB10CCU5 datasheet(24/110 Pages) STMICROELECTRONICS

24 / 110 page

Functional overview

STM32WB10CC

24/110

DS13259 Rev 2

independent clock can be clocked by HSI16. The RF subsystem is not available in this

mode and must be OFF.



Low-power sleep

This mode is entered from the low-power run mode. Only the CPU1 clock is stopped.

When wakeup is triggered by an event or an interrupt, the system reverts to the



low-power run mode. The RF subsystem is not available in this mode and must be

OFF.



Stop 0 and Stop 1

Stop modes achieve the lowest power consumption while retaining the content of all

the SRAM and registers. The LSE (or LSI) is still running.

The RTC can remain active (Stop mode with RTC, Stop mode without RTC).

Some peripherals with wakeup capability can enable the HSI16 RC during Stop modes

to detect their wakeup condition.

Two modes are available: Stop 0 and Stop 1.

Stop 1 offers several active peripherals and wakeup sources. In Stop 0 mode the main

regulator remains ON, allowing a very fast wakeup time but with higher consumption.

In these modes the RF subsystem can wait for incoming events in all Stop modes.

The system clock when exiting from Stop 0 Stop1 modes can be either MSI up to

48 MHz or HSI16 if the RF subsystem is disabled. If the RF subsystem is used the exits

must be set to HSI16 only.



Standby

The Standby mode is used to achieve the lowest power consumption with BOR. The

internal regulator is switched off so that the VCORE domain is powered off.

The RTC can remain active (Standby mode with RTC).

The brown-out reset (BOR) always remains active in Standby mode.

The state of each I/O during standby mode can be selected by software: I/O with

internal pull-up, internal pull-down or floating.

After entering Standby mode, register content is lost except for registers in the Backup

domain and Standby circuitry. Optionally, SRAMs can be retained in Standby mode,

supplied by the low-power regulator (Standby with 48 KB SRAM retention mode).

The device exits Standby mode when an external reset (NRST pin), an IWDG reset,

WKUP pin event (configurable rising or falling edge), or an RTC event occurs (alarm,

periodic wakeup, timestamp, tamper) or a failure is detected on LSE (CSS on LSE).

STM32WB10CCU5 датащи(PDF) 24 Page - STMicroelectronics