Pin Functions—Test Pads (continued)

Electrical Test Pad

DLP® System Board

H25

Do not connect.

H27

Do not connect.

H29

Do not connect.

H31

Do not connect.

H33

Do not connect.

H35

Do not connect.

H37

Do not connect.

H39

Do not connect.

H41

Do not connect.

6 Specifications

6.1 Absolute Maximum Ratings

over operating free-air temperature range (unless otherwise noted)(1)

MIN

MAX

UNIT

Supply Voltage

VCC

LVCMOS logic supply voltage(2)

–0.5

4

V

VOFFSET

Mirror electrode and HVCMOS voltage(2)

–0.5

8.75

V

VBIAS

Mirror electrode voltage

–0.5

17

V

|VBIAS – VOFFSET|

Supply voltage delta(3)

8.75

V

VRESET

Mirror electrode voltage

–11

0.5

V

Input Voltage

Input voltage: other inputs

See (2).

–0.5

VCC + 0.3

V

Clock Frequency

DCLK

Clock frequency

60

80

MHz

Environmental

TARRAY and TWINDOW

Temperature—operational(4)

–20

90

°C

Temperature—non-operational(4)

–40

90

°C

TDP

Dew point temperature—operating and

non-operating (non-condensing)

See note(5).

°C

|TDELTA|

Absolute temperature delta between any

point on the window edge and the ceramic

test point TP1(6)

30

°C

(1)

Operation outside the Absolute Maximum Ratings may cause permanent device damage. Absolute Maximum Ratings do not imply

functional operation of the device at these or any other conditions beyond those listed under Recommended Operating Conditions. If

outside the Recommended Operating Conditions but within the Absolute Maximum Ratings, the device may not be fully functional, and

this may affect device reliability, functionality, performance, and shorten the device lifetime.

(2)

All voltage values are with respect to GND (VSS). VOFFSET, VCC, VBIAS, VRESET and VSS power supplies are required for the normal

DMD operating mode.

(3)

To prevent excess current, the supply voltage delta |VBIAS – VOFFSET| must be less than 8.75 V.

(4)

The highest temperature of the active array (as calculated in Section 7.6) or of any point along the Window Edge as defined in Figure

7-1.

(5)

The DLP2000 DMD is intended for use in well controlled, low dew point environments. Please contact your local TI sales person or TI

distributor representative to determine if this device is suitable for your application and operating environment compared to other DMD

solutions. DLP® Products offers a broad portfolio of DMDs suitable for a wide variety of applications.

(6)

Temperature delta is the highest difference between the ceramic test point 1 (TP1) and anywhere on the window edge as shown in

Figure 7-1.

6.2 Storage Conditions

Applicable before the DMD is installed in the final product

MIN

MAX

UNIT

TDMD

DMD Temperature

–40

85

°C

DLP2000

DLPS140B – MARCH 2019 – REVISED MAY 2022

www.ti.com

6

Submit Document Feedback

Copyright © 2022 Texas Instruments Incorporated

Product Folder Links: DLP2000