TMPR3927 datasheet(21/512 Pages) TOSHIBA

21 / 512 page

3 General Safety Precautions and Usage Considerations

3-3

• When storing printed circuit boards which have devices mounted on them, use a board

container or bag that is protected against static charge. To avoid the occurrence of static charge

or discharge due to friction, keep the boards separate from one other and do not stack them

directly on top of one another.

• Ensure, if possible, that any articles (such as clipboards) which are brought to any location

where the level of static electricity must be closely controlled are constructed of anti-static

materials.

• In cases where the human body comes into direct contact with a device, be sure to wear anti-

static finger covers or gloves (suggested resistance value: 108

Ω or less).

• Equipment safety covers installed near devices should have resistance ratings of 109 Ω or less.

• If a wrist strap cannot be used for some reason, and there is a possibility of imparting friction

to devices, use an ionizer.

• The transport film used in TCP products is manufactured from materials in which static

charges tend to build up. When using these products, install an ionizer to prevent the film from

being charged with static electricity. Also, ensure that no static electricity will be applied to the

product’s copper foils by taking measures to prevent static occuring in the peripheral

equipment.

3.1.2

Vibration, impact and stress

Handle devices and packaging materials with care. To avoid damage

to devices, do not toss or drop packages. Ensure that devices are not

subjected to mechanical vibration or shock during transportation.

Ceramic package devices and devices in canister-type packages which

have empty space inside them are subject to damage from vibration

and shock because the bonding wires are secured only at their ends.

Plastic molded devices, on the other hand, have a relatively high level of resistance to vibration

and mechanical shock because their bonding wires are enveloped and fixed in resin. However,

when any device or package type is installed in target equipment, it is to some extent susceptible

to wiring disconnections and other damage from vibration, shock and stressed solder junctions.

Therefore when devices are incorporated into the design of equipment which will be subject to

vibration, the structural design of the equipment must be thought out carefully.

If a device is subjected to especially strong vibration, mechanical shock or stress, the package or

the chip itself may crack. In products such as CCDs which incorporate window glass, this could

cause surface flaws in the glass or cause the connection between the glass and the ceramic to

separate.

Furthermore, it is known that stress applied to a semiconductor device through the package

changes the resistance characteristics of the chip because of piezoelectric effects. In analog circuit

design attention must be paid to the problem of package stress as well as to the dangers of

vibration and shock as described above.

Vibration

TMPR3927 датащи(PDF) 21 Page - Toshiba Semiconductor

TMPR3927 датащи(HTML) 21 Page - Toshiba Semiconductor

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

датащи скачать

ссылки URL