CS42428 datasheet(22/73 Pages) CIRRUS

22 / 73 page

DS605F1

CS42428

4.3.3

Digital Volume and Mute Control

Each DAC’s output level is controlled via the Volume Control registers operating over the range of 0 to

-127 dB attenuation with 0.5 dB resolution. See “Volume Control (addresses 0Fh, 10h, 11h, 12h, 13h,

14h, 15h, 16h)” on page 53. Volume control changes are programmable to ramp in increments of

0.125 dB at the rate controlled by the SZC[1:0] bits in the Digital Volume Control register. See “Volume

Transition Control (address 0Dh)” on page 51.

Each output can be independently muted via mute control bits in the register “Channel Mute (address

0Eh)” on page 52. When enabled, each XX_MUTE bit attenuates the corresponding DAC to its maximum

value (-127 dB). When the XX_MUTE bit is disabled, the corresponding DAC returns to the attenuation

level set in the Volume Control register. The attenuation is ramped up and down at the rate specified by

the SZC[1:0] bits.

The Mute Control pin, MUTEC, is typically connected to an external mute control circuit. The Mute Control

pin outputs high impedance during Power-Up or in Power-Down Mode by setting the PDN bit in the reg-

ister “Power Control (address 02h)” on page 43 to a ‘1’. Once out of Power-Down Mode, the pin can be

controlled by the user via the control port, or automatically asserted high when zero data is present on all

DAC inputs, or when serial port clock errors are present. To prevent large transients on the output, it is

desirable to mute the DAC outputs before the Mute Control pin is asserted. Please see the MUTEC pin

in the Pin Descriptions section for more information.

Each of the GPO1-GPO7 can be programmed to provide a hardware MUTE signal to individual circuits.

Each pin can be programmed as an output, with specific muting capabilities as defined by the function

bits in the register “General-Purpose Pin Control (addresses 29h to 2Fh)” on page 58.

4.3.4

ATAPI Specification

The CS42428 implements the channel-mixing functions of the ATAPI CD-ROM specification. The

ATAPI functions are applied per A-B pair. Refer to Table 14 on page 54 and Figure 9 for additional infor-

mation.

ΣΣ

A Channel

Volum e

Control

AOUTAx

AOUTBx

Left Channel

Audio Data

Right Channel

Audio Data

BChannel

Volum e

Control

MUTE

DAC_SDINx

Figure 9. ATAPI Block Diagram (x = channel pair 1, 2, 3, 4)

CS42428 датащи(PDF) 22 Page - Cirrus Logic

CS42428 датащи(HTML) 22 Page - Cirrus Logic

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73

датащи скачать

ссылки URL