M700000002 datasheet(98/128 Pages) SPANSION

98 / 128 page

Am70PDL127BDH/Am70PDL129BDH

November 25, 2003

AD VAN C E

INFORM ATION

The write-buffer programming operation can be sus-

pended using the standard program suspend/resume

commands. Upon successful completion of the Write

Buffer Programming operation, the device is ready to

execute the next command.

The Write Buffer Programming Sequence can be

aborted in the following ways:

■ Load a value that is greater than the page buffer

size during the Number of Locations to Program

step.

■ Write to an address in a sector different than the

one specified during the Write-Buffer-Load com-

mand.

■ Write

Address/Data

pair

different

write-buffer-page than the one selected by the

Starting Address during the write buffer data load-

ing stage of the operation.

■ Write data other than the Confirm Command after

the specified number of data load cycles.

The abort condition is indicated by DQ1 = 1, DQ7 =

DATA# (for the last address location loaded), DQ6 =

toggle, and DQ5=0. A Write-to-Buffer-Abort Reset

command sequence must be written to reset the de-

vice for the next operation. Note that the full 3-cycle

Write-to-Buffer-Abort Reset command sequence is re-

quired when using Write-Buffer-Programming features

in Unlock Bypass mode.

Accelerated Program

The device offers accelerated program operations

through the WP#/ACC pin. When the system asserts

HH on the WP#/ACC pin, the device automatically en-

ters the Unlock Bypass mode. The system may then

write the two-cycle Unlock Bypass program command

sequence. The device uses the higher voltage on the

WP#/ACC pin to accelerate the operation.

Note that

the WP#/ACC pin must not be at V

HH for operations

other than accelerated programming, or device dam-

age may result. In addition, no external pullup is nec-

essary since the WP#/ACC pin has internal pullup to

VCC.

Figure 5 illustrates the algorithm for the program oper-

ation. Refer to the Erase and Program Operations

table in the AC Characteristics section for parameters,

and Figure 17 for timing diagrams.

M700000002 датащи(PDF) 98 Page - SPANSION

M700000002 датащи(HTML) 98 Page - SPANSION

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

датащи скачать

ссылки URL