RYZ024A

Datasheet

R19DS0115EU0101 Rev.1.01

Page 23 of 38

Nov.14.22

2. This device must accept any interference received, including interference that may

cause undesired operation.

• Further Labelling Requirements may apply dependent on the FCC rule parts relevant to the host product.

• End-product User Instructions / Notices in the Manual

At a minimum, end-product users must be provided with the following notices at a prominent location of

the product literature furnished with the product:



Product Modifications

Modifications not expressly approved by the party responsible for compliance could

void the user’s authority to operate this equipment.



RF Exposure Compliance

This equipment complies with FCC radio frequency radiation exposure rules and

limits set forth for an uncontrolled environment, when installed and operated with

minimum distance of 20cm between its radiating structures (antenna) and the body of

nearby persons and when not operated simultaneously with other nearby radio-

transmitters.

•

Maximum Antenna Gain

The user instructions of end-products equipped with standard external antenna connectors for the modular

radio transmitter providing the option to connect other antennae than those which may or may not be

bundled with the end-product must list the maximum allowed antenna gain values as derived from those

given above, accounting for the cable attenuations of the actual installation.

•

Digital Device – Unwanted Emissions Notice

If the end-product is or contains a digital device (unintentional radio portions) and is not exempted by its use

case (like vehicular use) the following part 15.105 (b) user notice shall be provided at prominent location of

the product literature:

This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to part 15 of the FCC rules. These limits are designed to

provide reasonable protection against harmful interference in a residential

installation.

This equipment generates uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful interference

to radio communications. However, there is no guarantee that interference will not

occur in a particular installation. If this equipment does cause harmful interference

to radio or television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or more of the

following measures: o Reorient or relocate the receiving antenna. O Increase the

separation between the equipment and receiver. O Connect the equipment into an outlet

on a circuit different from that to which the receiver is connected. O Consult the

dealer or an experienced radio/TV technician for help

• Further User Notices

May be required dependent on the FCC rule parts relevant to the host product.

• Non-allowed User Instructions

The end-product user guidance may NOT include instructions about how to install or de-install the

module.

ISED Regulatory Approval

This device complies with ISED’s licence exempt RSSs. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and (2) this device must accept any interference

received, including interference that may cause undesired operation.

Le 23isable appareil est conforme aux CNR de l’ISED applicables aux appareils radio exempts de licence.

L’exploitation est autorisée aux deux conditions suivantes : (1) le 23isabled23ve ne doit pas produire de

brouillage préjudiciable, et (2) ce 23isabled23ve doit supporter tout brouillage reçu, y compris un brouillage

susceptible de provoquer un fonctionnement indésirable.

This device is intended only for OEM integrators under the following conditions: (For module device use)

1.

The antenna must be installed such that 20 cm is maintained between the antenna and users, and