8 Application and Implementation

Note

Information in the following applications sections is not part of the TI component specification,

and TI does not warrant its accuracy or completeness. TI’s customers are responsible for

determining suitability of components for their purposes, as well as validating and testing their design

implementation to confirm system functionality.

8.1 Application Information

Generating accurate, stable, programmable dc voltages is a key requirement in most precision end equipment.

The DAC82002 is an excellent choice for such applications. The DAC82002 tiny package, high resolution,

fast settling, and simple interface makes this device a great choice for applications such as offset and gain

control, arbitrary waveform generation (AWG), closed-loop control, and more. With the aforementioned features,

the DAC82002 caters to a wide range of end equipment, such as battery testers, communications equipment,

factory automation and control, test and measurement, and more. Many compatible operational amplifiers can

be used as output buffers for the DAC82002, allowing for user customization.

8.2 Typical Application

8.2.1 Arbitrary Waveform Generator

Arbitrary waveform generation circuits are common in test and measurement equipment. These circuits are used

to generate ac waveforms to test devices. The key performance parameters of such circuits are THD, SNR, and

the update rate. The following figure shows a basic example of an AWG circuit using the DAC82002.

DAC82002

47 pF

100 nF

+

–

OPA2328

+

–

VOUTA

VOUTB

+5 V

+5 V

Figure 8-1. Arbitrary Waveform Generator

8.2.1.1 Design Requirements

• DAC output range: 0 V to 2.5 V

• THD+N at 1 kHz: > 91 dB

• Update rate: 200 kHz

8.2.1.2 Detailed Design Procedure

Figure 8-1 shows a simplified circuit diagram of an arbitrary waveform generator. The DAC82002 specifies a

THD+N of 91 dB at 1 kHz. The OPA2328 provides a great balance between fast settling, bandwidth, and voltage

and current noise. The buffer must have a negative voltage supply rail or an output offset to make sure the DAC

output is not clipped. Attach two decoupling capacitors as close as possible to the VREF pin. Use 100 nF for the

first capacitor to provide very good noise performance for the system. Use 47 pF for the other capacitor to allow

for a good dynamic response performance that improves any code-to-code glitch.

DAC82002

SBASAK1 – AUGUST 2022

www.ti.com

14

Submit Document Feedback

Copyright © 2022 Texas Instruments Incorporated

Product Folder Links: DAC82002