MPC5644BCAMMJ1 datasheet(114/116 Pages) NXP

114 / 116 page

MPC5646C Microcontroller DataSheet, Rev. 7

Revision history

NXP Semiconductors

114

NOTE

This revision history uses clickable cross-references for ease of navigation. The numbers

and titles in each cross-reference are relative to the latest published release.

12 Feb 2014

• Removed occurrences of 208BGA from Table 2 Bolero 3M family comparison.

• Added PM[3] and PM[4] in the figure note 1 of Figure 5, 256-pin BGA

configuration.

• Added a table note in Table 19 I/O supplies.

• Updated Figure 8, Voltage regulator capacitance connection and added a note in

this figure.

• Removed max values of VLPREG and VMREG, changed min value of VLPREG to 1.21

V, and updated VMREG and VLPREG after trimming values in Table 22 Voltage

regulator electrical characteristics.

• Updated 1st footnote and updated max values for IDDRUN, IDDHALT, IDDSTOP,

IDDSTDBY3, IDDSTDBY2, IDDSTDBY1 and removed values at 85

oC and 105oC in

Table 24 Low voltage power domain electrical characteristics.

• Added a footnote below Table 28 Flash memory read access timing.

• Updated the formula in Eq. 11 in Section 4.17.1.1, “Input impedance and ADC

accuracy.

• Added Figure 17, Input equivalent circuit (extended channels).

• Updated tADC0_PU value to 1.5 as max and added footnote for IINJ in Table 42 ADC

conversion characteristics (10-bit ADC_0).

• Added Category column in Table 43 Conversion characteristics (12-bit ADC_1).

• Added the IDD_HV_ADC0 values in Table 48 On-chip peripherals current

consumption.

• Added a note in Figure 49, Orderable parts.

10 October 2021

• In 6, “Ordering information, added Fab and Mask indicator.

Table 52. Revision history (continued)

Revision

Date

Changes

MPC5644BCAMMJ1 датащи(PDF) 114 Page - NXP Semiconductors