STM32L031C6 datasheet(79/126 Pages) STMICROELECTRONICS

79 / 126 page

DS10668 Rev 6

79/126

STM32L031x4/6

Electrical characteristics

Static latch-up

Two complementary static tests are required on six parts to assess the latch-up

performance:

•

A supply overvoltage is applied to each power supply pin

•

A current injection is applied to each input, output and configurable I/O pin

These tests are compliant with EIA/JESD 78A IC latch-up standard.

6.3.12

I/O current injection characteristics

As a general rule, current injection to the I/O pins, due to external voltage below VSS or

above VDD (for standard pins) must be avoided during normal product operation. However,

in order to give an indication of the robustness of the microcontroller in cases when

abnormal injection accidentally happens, susceptibility tests are performed on a sample

basis during device characterization.

Functional susceptibility to I/O current injection

While a simple application is executed on the device, the device is stressed by injecting

current into the I/O pins programmed in floating input mode. While current is injected into

the I/O pin, one at a time, the device is checked for functional failures.

The failure is indicated by an out of range parameter: ADC error above a certain limit (higher

than 5 LSB TUE), out of conventional limits of induced leakage current on adjacent pins (out

of –5 µA/+0 µA range), or other functional failure (for example reset occurrence oscillator

frequency deviation).

The test results are given in the Table 52.

Table 51. Electrical sensitivities

Symbol

Parameter

Conditions

Class

Static latch-up class

TA = +125 °C conforming to JESD78A

II level A

Table 52. I/O current injection susceptibility

Symbol

Description

Functional susceptibility

Unit

Negative

injection

Positive

injection

IINJ

Injected current on BOOT0

–0

NA(1)

1. Current injection is not possible.

Injected current on PA0, PA2, PA4, PA5,

PC15, PH0 and PH1

–5

Injected current on any other FT and FTf

–5 (2)

2. It is recommended to add a Schottky diode (pin to ground) to analog pins which may potentially inject

negative currents.

NA(1)

Injected current on any other pin

–5 (2)

STM32L031C6 датащи(PDF) 79 Page - STMicroelectronics

STM32L031C6 датащи(HTML) 79 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

датащи скачать

ссылки URL