SLK2511

OC-48/24/12/3 SONET/SDH MULTIRATE TRANSCEIVER

SLLS522A – JUNE 2002 – REVISED OCTOBER 2002

10

POST OFFICE BOX 655303

jitter tolerance (continued)

f0

f1

f2

f3

f4

Frequency – Hz

A3

A2

A1

Slope = –20 dB / Decade

Slope = –20 dB / Decade

OC-N/STS-N

LEVEL

f0

(Hz)

F1

(Hz)

F2

(Hz)

F3

(kHz)

F4

(kHz)

A1

(Ulpp)

A2

(Ulpp)

A3

(Ulpp)

3

10

30

300

6.5

65

0.15

1.5

15

12

10

30

300

25

250

0.15

1.5

15

24

Not specified

48

10

600

6000

100

1000

0.15

1.5

15

Figure 3. Input Jitter Tolerance

jitter generation

no jitter is presented to the inputs. The measurement bandwidth for intrinsic jitter is 12 kHz to 20 MHz.

loop timing mode

When LOOPTIME is high, the clock synthesizer used to serialize the transmit data is bypassed and the timing

is provided by the recovered clock. However, REFCLK is still needed for the recovery loop operation.

loss of lock indicator

The SLK2511 has a lock detection circuit to monitor the integrity of the data input. When the clock recovery loop

is locked to the input serial data stream, the LOL signal goes high. If the recovered clock frequency deviates

from the reference clock frequency by more than 100 ppm, LOL goes low. If the data stream clock rate deviates

by more than 170 ppm, loss of lock occurs. If the data streams clock rate deviates more than 500 ppm from the

local reference clock, the LOL output status might be unstable. Upon power up, the LOL goes low until the PLL

is close to phase lock with the local reference clock.

loss of signal

The loss of signal (LOS) alarm is set high when no transitions appear in the input data path for more than 2.3

µs.

The LOS signal becomes active when the above condition occurs. If the serial inputs of the device are

ac-coupled to its source, the ac-couple capcitor needs to be big enough to maintain a signal level above the

threshold of the receiver for the 2.3

µs no transition period. Once activated, the LOS alarm pin is latched high

until the receiver detects an A1A2 pattern. The recovered clock (RXCLK) is automatically locked to the local

reference when LOS occurs. The parallel data (RXDATAx) may still be processed even when LOS is activated.