SLK2511

OC-48/24/12/3 SONET/SDH MULTIRATE TRANSCEIVER

SLLS522A – JUNE 2002 – REVISED OCTOBER 2002

8

POST OFFICE BOX 655303

detailed description (continued)

Table 4. Programmable De-Emphasis

PRE1

PRE2

DE-EMPHASIS LEVEL

(V(ODp)d/V(ODd)† – 1)

0

0

De-emphasis disabled

1

0

10%

0

1

20%

1

1

30%

† V(ODp): Differential voltage swing when there is a transition in the data

stream.

V(ODd): Differential voltage swing when there is no transition in the data

stream.

V(ODd)

V(ODp)

V(ODp)

V(ODd)

Bit

Time

Bit

Time

0

Figure 1. Output Differential Voltage Under De-Emphasis

LVDS parallel data interface

The parallel data interface consists of a 4-bit parallel LVDS data and clock. The device conforms to OIF99.102

specification when operating at the OC-48 rate. When operating at lower serial rates the clock and data

frequency are scaled down accordingly, as indicated in Table 1. The parallel data TXDATA[0:3] is latched on

the rising edge of the TXCLK and then is sent to a data FIFO to resolve any phase difference between TXCLK

and REFCLK. If there is a FIFO overflow condition, the SPILL pin is set high. The FIFO resets itself to realign

between two clocks. The internal PLL for the clock synthesizer is locked to the REFCLK and it is used as the

timing to serialize the parallel data (except for the loop timing mode where the recovered clock is used). On the

receive side, RXDATA[0:3] is updated on the rising edge of RXCLK. Figure 7 and Figure 8 show the timing

diagram for the parallel interface.

The SLK2511 also has a built-in parity checker and generator for error detection of the LVDS interface. On the

transmit side, it accepts the parity bit, TXPARP/N, and performs the parity checking function for even parity. If

an error is detected, it pulses the PAR_VALID pin low for two clock cycles. On the receive side, the parity bit

RXPARP/N is generated for the downstream device for parity error checking.

Differential termination 100-

Ω resistors are included on-chip between TXDATAP/N.

reference clock

The device accepts either a 155.52-MHz or a 622.08-MHz clock. A clock select pin (REFCLKSEL) allows the

selection of the external reference clock frequency. The REFCLK input is compatible with the LVDS level and

also the 3.3-V LVPECL level using ac-coupling. A 100-

Ω differential termination resistor is included on-chip, as

well as a dc biasing circuit (3 k

Ω to VDD and 4.5 kΩ to GND) for the ac-coupled case. A high quality REFCLK

must be used on systems required to meet SONET/SDH standards. For non-SONET/SDH compliant systems,

loose tolerances may be used.