Output Voltage in

normal regulation

Dropout

Transient response

time of the LDO

Load current

discharges

output

voltage

Time

VGS voltage for

normal operation

VGS voltage in

dropout (pass device

fully on)

Gate Voltage

Input Voltage

VGS voltage for

normal operation

Input Voltage

Output Voltage

VGS voltage

(pass device

fully off)

18

TLV752

SBVS383 – DECEMBER 2019

www.ti.com

Product Folder Links: TLV752

Submit Documentation Feedback

Copyright © 2019, Texas Instruments Incorporated

Application Information (continued)

Figure 42. Line Transients From Dropout

8.1.5 Reverse Current

As with most LDOs, excessive reverse current can damage this device.

Reverse current flows through the body diode on the pass element instead of the normal conducting channel. At

high magnitudes, this current flow degrades the long-term reliability of the device, as a result of one of the

following conditions:

•

Degradation caused by electromigration

•

Excessive heat dissipation

•

Potential for a latch-up condition

Conditions where reverse current can occur are outlined in this section, all of which can exceed the absolute

•

•

The output is biased when the input supply is not established

•

The output is biased above the input supply