OPA607 datasheet(30/50 Pages) TI1

30 / 50 page

/ (2

)

GBWP

R C

GBWP

R C

VBIAS

20 pF

CPCB

0.3 pF

OPA810

+5 V

-5 V

CF + CPCB

1.03 pF

Oscillosco pe

with 50-

Inputs

100 k

Sup ply Decouplin g n ot

shown

OPA810

SBOS799A – AUGUST 2019 – REVISED DECEMBER 2019

www.ti.com

Product Folder Links: OPA810

Submit Documentation Feedback

9.2 Typical Applications

9.2.1 Transimpedance Amplifier

The high GBWP and low input voltage and current noise for the OPA810 make the device an ideal wideband

transimpedance amplifier for moderate to high transimpedance gains.

Figure 73. Wideband, High-Sensitivity, Transimpedance Amplifier

9.2.1.1 Design Requirements

Table 2 lists the design requirements for a high-bandwidth, high-gain transimpedance amplifier circuit.

Table 2. Design Requirements

PARAMETER

DESIGN REQUIREMENT

Target bandwidth

> 2 MHz

Transimpedance gain

100 kΩ

Photodiode capacitance

20 pF

9.2.1.2 Detailed Design Procedure

Designs that require high bandwidth from a large area detector with relatively high transimpedance gain benefit

from the low input voltage noise of the OPA810. This input voltage noise is peaked up over frequency by the

diode source capacitance, and can (in many cases) become the limiting factor to input sensitivity. The key

elements to the design are the expected diode capacitance (CD) with the reverse bias voltage (VBIAS) applied, the

desired transimpedance gain, RF, and the GBWP for the OPA810 (70 MHz). Figure 73 shows a transimpedance

circuit with the parameters as described in Table 2. With these three variables set (and including the parasitic

input capacitance for the OPA810 and the printed circuit board (PCB) added to CD), the feedback capacitor value

(CF) can be set to control the frequency response. The Transimpedance Considerations for High-Speed

Amplifiers application report discusses using high-speed amplifiers for transimpedance applications. Set the

feedback pole according to Equation 9 in order to achieve a maximally-flat second-order Butterworth frequency

response:

(9)

The input capacitance of the amplifier is the sum of the common-mode and differential capacitance (2.0 +

0.5) pF. The parasitic capacitance from the photodiode package and the PCB is approximately 0.3 pF. Using

Equation 5 gives a total input capacitance of CD = 22.8 pF. From Equation 9, set the feedback pole at 1.55 MHz.

Setting the pole at 1.55 MHz requires a total feedback capacitance of 1.03 pF.

Equation 10 shows the approximate –3-dB bandwidth of the transimpedance amplifier circuit:

(10)

OPA607 датащи(PDF) 30 Page - Texas Instruments

OPA607 датащи(HTML) 30 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50

датащи скачать

ссылки URL