| поискавой системы для электроныых деталей |
|
GS3470 датащи(PDF) 28 Page - Semtech Corporation |
|
|
|||||||||||||||||||||||||||||
GS3470 датащи(HTML) 28 Page - Semtech Corporation |
|
28 / 169 page ![]() GS3470 Final Data Sheet Rev.8 PDS-060500 September 2017 28 of 169 Semtech www.semtech.com The LOCKED output signal is available by default on the STAT3 output pin, but can be programmed to be output through any one of the six programmable multi-functional pins of the device, STAT[5:0]. Note: In Power-down mode with RC_BYP disabled, the PLL unlocks. However, the LOCKED signal retains whatever state it previously held. For instance, if before power-down assertion the LOCKED signal is HIGH, during power-down it will remain HIGH regardless of the status of the PLL. 4.9 Parallel Data Outputs A 20-bit parallel bus is available which can be configured in 10-bit or 20-bit mode.The parallel data outputs are aligned to the rising edge of the PCLK. 4.9.1 Parallel Data Bus Output Levels The parallel data bus supports 1.8V or 2.5V (LVTTL and LVCMOS levels) supplied at the IO_VDD pins. 4.9.2 Parallel Output in SMPTE Mode When the device is operating in SMPTE mode (SMPTE_BYPASS = HIGH), data is output in either multiplexed or demultiplexed form depending on the setting of the 20BIT_10BIT pin or PIN_CSR_SELECT register (877h). When operating in 20-bit mode (20BIT_10BIT = HIGH), the output data is demultiplexed Luma (DOUT[19:10]) and Chroma (DOUT[9:0]) data for SD and HD data rates. For 3G data rate, Data Stream 1 is output on the DOUT[19:10] pins and Data Stream 2 is output on the DOUT[9:0] pins. When operating in 10-bit mode (20BIT_10BIT = LOW), the output data format is multiplexed Luma and Chroma data. In this mode, the data is presented on the DOUT[19:10] pins, with DOUT[9:0] being forced LOW. For SD/ HD data rates, the clock is either at the 10-bit word rate or at half of this rate (DDR mode). For 3G data rates, the clock is always at half the 10-bit word rate (DDR mode). DVB-ASI Mode SMPTE_BYPASS = LOW DVB_ASI = HIGH Retimer PLL is locked to a DVB-ASI stream. Data-Through Mode SMPTE_BYPASS = LOW DVB_ASI = LOW Retimer PLL is locked. Table 4-4: Lock Detect Conditions (Continued) Mode of Operation Mode Setting Condition for Locked |
|
ссылки URL |
| Вашему бизинису помогли Аллдатащит? [ DONATE ] |
Что такое Аллдатащит | реклама | контакт | Конфиденциальность | Ссылка на техническое описание | обмен ссыками | поиск по производителю All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |