| поискавой системы для электроныых деталей |
|
MFC2000 датащи(PDF) 140 Page - List of Unclassifed Manufacturers |
|
|
|||||||||||||||||||||||||||||
MFC2000 датащи(HTML) 140 Page - List of Unclassifed Manufacturers |
|
140 / 426 page ![]() MFC2000 Multifunctional Peripheral Controller 2000 Hardware Description 5-14 Conexant 100723A Address: Bit 15 Bit 14 Bit 13 Bit 12 Bit 11 Bit 10 Bit 9 Bit 8 Default: Watchdog Interval (WatchdogInterval) 01FF8043 (Not Used) Rst. Value xxh Read Value 00h Address: Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0 Default: Watchdog Interval (WatchdogInterval) 01FF8042 Watchdog Interval (n = 0-255) (n*1ms) Rst. Value 00h Read Value 00h • Once enabled, the Watchdog Timer can only be disabled by reset. • On reset, the Watchdog Timer is disabled until it is enabled by writing to the WatchdogInterval register followed by writing $0F and $F0 to the WatchdogEnRetrigger register. • The basic Watchdog time-out unit (1 ms) is based on the internal 125 µsec timer. Therefore, the 125µsPrescaler and MSINTPeriod registers (used to activate the timer) must be set in order to operate the Watchdog Timer. • The accuracy of the time-out period is equal to the accuracy of the 125 µsec timer with an additional error of up to 1 msec (i.e., the amount of error is dependent on the relationship of the trigger point to the internal 1 msec timer). • If N is programmed into the WatchdogInterval register, the Watchdog Timer time-out period is "N * 1 ms" (N = 0 - 255). • Reading the address of the WatchdogInterval register returns the value of N that was programmed into the WatchdogInterval register. • The following conditions do not enable the watchdog timer: Only the first write to the WatchdogInterval register is valid. The subsequent writes to this register are ignored. Any other data written to the WatchdogEnRetrigger register between the times $0F and $F0 are written is ignored. Once enabled, the Watchdog Timer is retriggered on the writing of alternate $0F and $F0. (Writing of any other data, and the writing of repetitive $0F or $F0 is ignored.) |
|
ссылки URL |
| Вашему бизинису помогли Аллдатащит? [ DONATE ] |
Что такое Аллдатащит | реклама | контакт | Конфиденциальность | Ссылка на техническое описание | обмен ссыками | поиск по производителю All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |