CP5.241, CP5.241-C1,

CP5.241-S1, CP5.241-S2

CP-Series

Aug. 2017 / Rev. 0.1 DS-CP5.241-EN

All parameters are typical values specified at 24V, 5A output, 230Vac input, 25°C ambient and

after a 5 minutes run-in time unless otherwise noted.

www.pulspower.com Phone +49 89 9278 0

Germany

P R E L I M I N A R Y

CP5.241-S2

Input

Output

DC-OK-Signal

Type

Push-in termination

Push-in termination

Push-in termination

Solid wire

Stranded wire

Stranded wire with ferrules

American Wire Gauge

AWG 24-12

AWG 24-8

AWG 24-16

Max. wire diameter (including ferrules)

2.3mm

3.3mm

1.6mm

Wire stripping length

10mm / 0.4inch

15mm / 0.6inch

7mm / 0.28inch

Screwdriver

3.0mm slotted to open

the spring

3.5mm slotted to open

the spring

3mm slotted to open

the spring

Instructions for wiring:

a)

Use appropriate copper cables that are designed for minimum operating temperatures of:

60°C for ambient up to 45°C and

75°C for ambient up to 60°C and

90°C for ambient up to 70°C minimum.

b)

Follow national installation codes and installation regulations!

c)

Ensure that all strands of a stranded wire enter the terminal connection!

d)

Unused terminal compartments should be securely tightened.

e)

Ferrules are allowed.

Daisy chaining:

Daisy chaining (jumping from one power supply output to the next) is allowed as long as the average output current

through one terminal pin does not exceed 25A or 15A for the CP5.241-S2. If the current is higher, use a separate

distribution terminal block as shown in Fig. 13-2.

Fig. 13-1 Daisy chaining of outputs

Fig. 13-2 Using distribution terminals

Load

+

-

Power

Supply

+ +

- -

Output

Power

Supply

+ +

- -

Output

Maximal 15A continuous for CP5.241-S2

Maximal 25A continuous for all other units

Distribution

Terminals

Load

+

-

Power

Supply

+ +

- -

Output

Power

Supply

+ +

- -

Output

12/26