L99MC6GJ datasheet(36/55 Pages) STMICROELECTRONICS

36 / 55 page

SPI control and status register

L99MC6GJ

36/55

DocID026835 Rev 3

9.3.2

Note:

Every output stage is protected against overtemperature and overcurrent. While still

configured as ON, the output stage can be deactivated by the corresponding error bits in the

status registers. In order to reactivate the drivers, the status registers have to be cleared by

a specific SPI command.

High

Low

Yes

Low

IN/PWM(2)

Yes

High

Off

IN/PWM(2)

Yes

Low

1. The state of the channel 2 is according to the IN/PWM signal

2. The output state is according to the IN/PWM signal, note that bridge mode and PWM mode may not be activated at the

same time for channels 2 and 5.

Table 29. Channel configuration decoding (continued)

CHx

[2]

CHx

[1]

CHx

[0]

CHx

PWM

mode

Overcurrent

recovery

Slew Rate

Open-load

detection

Table 30. Register description

Name

Comment

Global device enable bit. If this bit is reset, the device goes in standby mode.

CHx

[2:0]

Channel output configuration (see Table 29).

Note that channel 2 is directly driven by the external IN/PWM pin and thus can not be configured

independently from the PWM configuration of other channels.

Bridge

Activate Bridge mode between channels 3 and 6, channels 2 and 5, channels 1 and 4. Any

polarity change is delayed by masking time of cross conduction protection

If wrong SPI commands try to turn on the channels 3 and 6, channels 2 and 5, channels 1 and 4

simultaneously, the high-side (channels 3, 2, 1) has the priority whereas channels 6, 5, 4 is (or

stay) deactivated.

ENCP

This bit is preset to ‘1’ at startup. To deactivate the internal charge pump ENCP has to be reset

together with setting DISCP (CTRL 2). This mechanism avoids unwanted charge pump

deactivation after an undetected communication error.

It is recommended to check the state of the charge pump deactivation bits at every access of

CTRL 1 and CTRL 2.

DISCP

This bit is reset to ‘0’ at startup. To deactivate the internal charge pump DISCP has to be set

together with resetting ENCP (CTRL 1)

TSD

Overtemperature detected: all the drivers are shutdown

TWARN

Overtemperature warning level detected, information only

OL [6:1]

Open-load error detected, information only

OC [6:1]

Overcurrent error detected, drivers are deactivated and re-enabled cyclically when bulb mode is

configured. Note: in order to detect a real overload condition, the application software must make

sure, that the corresponding OC bit remains cleared after a maximum heat up time of the load.

L99MC6GJ датащи(PDF) 36 Page - STMicroelectronics

L99MC6GJ датащи(HTML) 36 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55

датащи скачать

ссылки URL