CT10.241

C-Series

DC input

nom.

DC 600V

DC input range

min.

450-780Vdc

continuous operation

Allowed Voltage Line to Earth

max.

820Vdc

IEC 62103

DC input current

typ.

0.58A / 0.34A

450Vdc / 780Vdc, at 24V, 10A

Turn-on voltage

typ.

370Vdc

steady state value

Shut-down voltage

typ.

260Vdc

steady state value

Fig. 4-1 Wiring for DC Input

Instructions for DC use:

+

-

Load

L1

PE

+

-

Power Supply

AC

DC

Battery

L2

L3

FUSE

FUSE

a) Use a battery or similar DC source.

For other sources contact PULS

b) Connect +pole to L1 and –pole to L2.

c) Terminal L3 remains unused, terminal screw of L3 must be

securely tightened.

d) Use appropriate external fuses in the + and – lines which

are suitable for the DC-voltage.

e) Connect the PE terminal to a earth wire or to the machine

ground.

f) DC-operation is not included in the UL approval.

Additional testing might be necessary.

An active inrush limitation circuit limits the input inrush current after turn-on of the input voltage and after short

input voltage interruptions.

The charging current into EMI suppression capacitors is disregarded in the first microseconds after switch-on.

3AC 400V

3AC 480V

Inrush current

max.

-25°C to +70°C

typ.

-25°C to +70°C

Inrush energy

max.

-25°C to +70°C

Fig. 5-1 Input inrush current, typical behavior

Output Voltage

Input Voltage

Input Current

20ms / DIV

Input:

3x 400Vac

Output:

24V, 10A

Ambient:

25°C

Upper curve:

Input current 1A / DIV

Middle curve:

Input voltage 500V / DIV

Lower curve:

Output voltage 10V / DIV

Time basis:

20ms / DIV

Jan. 2010 / Rev. 1.3 DS-CT10.241-EN

All parameters are specified at 24V, 10A, 3x400Vac, 25°C ambient and after a 5 minutes run-in time unless otherwise noted.

www.pulspower.com Phone +49 89 9278 0

Germany

5/22