WM8753LEBSLASHRV datasheet(61/87 Pages) WOLFSON

61 / 87 page

WM8753L

Advanced Information

AI Rev 3.1 June 2004

ADDRESS

BIT

LABEL

DEFAULT

DESCRIPTION

3:2

IFMODE [1:0]

Interface mode

00 = Voice Codec + HiFi DAC.

01 = Voice Codec on HiFi interface.

10 = HiFi over HiFi interface.

11 = HiFi over HiFi interface, using

VXFS for ADC frame sync.

VXFSOE

Configures direction of VXFS pin in

master mode

0 = Pin is input

1 = Pin is output

R5 (05h)

Digital

Audio

Interface

Control

LRCOE

Configures direction of LRC pin in

master mode

0 = Pin is input

1 = Pin is output

Table 56 Audio Interface Control

Control bits VXCLKTRI, BCLKTRI, VXDTRI and ADCDTRI configure the Hi-Fi and Voice

interface pins BCLK, VXCLK, ADCDAT and VXDOUT as inputs or tristate. This allows the I

and PCM interfaces to be connected to an interface bus and all outputs onto the bus tristated

or switched to inputs. The default state for all audio interface PMS is input or tristate.

ADDRESS

BIT

LABEL

DEFAULT

DESCRIPTION

VXCLKTRI

VXCLK tristate

0 = VXCLK pin configured as input or

output as set by PMS

1 = VXCLK pin tristated and used as

input

BCLKTRI

BCLK tristate

0 = BCLK pin configured as input or

output as set by MS

1 = BCLK pin tristated and used as input

VXDTRI

VXDOUT tristate

0 = VXDOUT pin enabled as output

1 = VXDOUT pin tristated

R5 (05h)

Digital Audio

Interface

Control

ADCDTRI

ADCDAT tristate

0 = ADCDAT pin enabled as output

1 = ADCDAT pin tristated

Table 57 PCM and Hi-Fi Interface Tristate

CONTROL INTERFACE

SELECTION OF CONTROL MODE AND 2-WIRE MODE ADDRESS

The control interface can operate as either a 3-wire or 2-wire MPU interface. The MODE/GPIO3 pin is

sampled at power-up, latched and used to select the interface format. After power-up MODE/GPIO3

is available for general purpose use. The CSB/GPIO5 pin is also sampled and latched on power-up

and, if 2-wire mode is selected, the latched value selects the 2-wire mode address. For 3-wire mode

CSB/GPIO5 is always an input. After power-up in 2-wire mode CSB/GPIO5 is available for general

purpose use. See MODE/GPIO3 and CSB/GPIO5 LATCH on Power-up Timing Information on page

The WM8753L is controlled by writing to registers through a serial control interface. A control word

consists of 16 bits. The first 7 bits (B15 to B9) are address bits that select which control register is

accessed. The remaining 9 bits (B8 to B0) are register bits, corresponding to the 9 bits in each control

WM8753LEB/RV датащи(PDF) 61 Page - Wolfson Microelectronics plc

WM8753LEB/RV датащи(HTML) 61 Page - Wolfson Microelectronics plc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87

датащи скачать

ссылки URL