17

TUSB1002

www.ti.com

SLLSEU4A – MAY 2016 – REVISED MAY 2016

Product Folder Links: TUSB1002

Submit Documentation Feedback

Copyright © 2016, Texas Instruments Incorporated

7.7 U2/U3 Mode

Next to the disconnect mode, the U2/U3 mode is next lowest power state. While in this mode, the TUSB1002

periodically performs far-end receiver detection. Anytime the far-end receiver termination is not detected on

either CH1 or CH2, the TUSB1002 leaves the U2/U3 mode and transition to the Disconnect mode. It also

monitors the SSRX1 and SSRX2 for a valid LFPS. Upon detection of a valid LFPS, the TUSB1002 immediately

transitions to the U0 mode.

When SLP_S0# is asserted low and the TUSB1002 is in U2/U3 mode, the TUSB1002 remains in U2/U3 state

and never perform far-end receiver detection. While in this state, the TUSB1002 ignores LFPS signaling. This

allows even lower TUSB1002 power consumption while in the U2/U3 mode. Once SLP_S0# is asserted high, the

TUSB1002 again starts performing far-end receive as well as monitor LFPS so it can know when to exit the

U2/U3 mode.