GD25Q32C datasheet(10/50 Pages) ELM

10 / 50 page

Rev.1.0

50 -

http://www.elm-tech.com

GD25Q32CxIGx 3.3V Uniform Sector Dual and Quad Serial Flash

6. STATUS REGISTER

The status and control bits of the Status Register are as follows:

WIP bit.

The Write in Progress (WIP) bit indicates whether the memory is busy in program/erase/write status register

progress. When WIP bit sets to 1, means the device is busy in program/erase/write status register progress, when

WIP bit sets 0, means the device is not in program/erase/write status register progress.

WEL bit.

The Write Enable Latch (WEL) bit indicates the status of the internal Write Enable Latch. When set to 1 the

internal Write Enable Latch is set, when set to 0 the internal Write Enable Latch is reset and no Write Status

BP4, BP3, BP2, BP1, BP0 bits.

The Block Protect (BP4, BP3, BP2, BP1 and BP0) bits are non-volatile. They define the size of the area to be

software protected against Program and Erase commands. These bits are written with the Write Status Register

(WRSR) command. When the Block Protect (BP4, BP3, BP2, BP1 and BP0) bits are set to 1, the relevant

memory area (as defined in Table1). becomes protected against Page Program (PP), Sector Erase (SE) and Block

Erase (BE) commands. The Block Protect (BP4, BP3, BP2, BP1 and BP0) bits can be written provided that

the Hardware Protected mode has not been set. The Chip Erase (CE) command is executed, only if the Block

Protect (BP2, BP1 and BP0) bits are 0 and CMP=0.

SRP1, SRP0 bits.

The Status Register Protect (SRP1 and SRP0) bits are non-volatile Read/Write bits in the status register. The

SRP bits control the method of write protection: software protection, hardware protection, power supply lock-

down or one time programmable protection.

S15

S14

S13

S12

S11

S10

SUS1

CMP

LB3

LB2

LB1

SUS2

SRP1

SRP0

BP4

BP3

BP2

BP1

BP0

WEL

WIP

SRP1 SRP0 #WP

Status Register

Description

Software Protected The Status Register can be written to after a Write Enable

command, WEL=1.(Default)

Hardware Protected WP#=0, the Status Register locked and can not be written to.

Hardware Unprotected WP#=1, the Status Register is unlocked and can be written to

after a Write Enable command, WEL=1.

Power Supply

Lock-Down(1)

Status Register is protected and can not be written to again until

the next Power-Down, Power-Up cycle.

One Time Program(2) Status Register is permanently protected and can not be written to.

S23

S22

S21

S20

S19

S18

S17

S16

Reserved

DRV1

DRV0

HPF

Reserved

GD25Q32C датащи(PDF) 10 Page - ELM Electronics

GD25Q32C датащи(HTML) 10 Page - ELM Electronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50

датащи скачать

ссылки URL