LP3971 datasheet(17/52 Pages) TI1

17 / 52 page

LP3971

www.ti.com

SNVS432V – JANUARY 2006 – REVISED MAY 2013

BUCK CONVERTER OPERATION

DEVICE INFORMATION

The LP3971 includes three high efficiency step down DC-DC switching buck converters. Using a voltage mode

architecture with synchronous rectification, the buck converters have the ability to deliver up to 1600 mA

depending on the input voltage, output voltage, ambient temperature and the inductor chosen.

There are three modes of operation depending on the current required - PWM, PFM, and shutdown. The device

operates in PWM mode at load currents of approximately 100 mA or higher, having voltage tolerance of ±3%

with 95% efficiency or better. Lighter load currents cause the device to automatically switch into PFM for reduced

current consumption. Shutdown mode turns off the device, offering the lowest current consumption (IQ, SHUTDOWN

= 0.01 µA typ).

Additional features include soft-start, under voltage protection, current overload protection, and thermal shutdown

protection.

The part uses an internal reference voltage of 0.5V. It is recommended to keep the part in shutdown until the

input voltage is 2.7V or higher.

CIRCUIT OPERATION

The buck converter operates as follows. During the first portion of each switching cycle, the control block turns

on the internal PFET switch. This allows current to flow from the input through the inductor to the output filter

capacitor and load. The inductor limits the current to a ramp with a slope of (VIN–VOUT)/L, by storing energy in a

magnetic field.

During the second portion of each cycle, the controller turns the PFET switch off, blocking current flow from the

input, and then turns the NFET synchronous rectifier on. The inductor draws current from ground through the

NFET to the output filter capacitor and load, which ramps the inductor current down with a slope of –VOUT/L.

The output filter stores charge when the inductor current is high, and releases it when inductor current is low,

smoothing the voltage across the load.

The output voltage is regulated by modulating the PFET switch on time to control the average current sent to the

load. The effect is identical to sending a duty-cycle modulated rectangular wave formed by the switch and

synchronous rectifier at the SW pin to a low-pass filter formed by the inductor and output filter capacitor. The

output voltage is equal to the average voltage at the SW pin.

PWM OPERATION

During PWM operation the converter operates as a voltage mode controller with input voltage feed forward. This

allows the converter to achieve good load and line regulation. The DC gain of the power stage is proportional to

the input voltage. To eliminate this dependence, feed forward inversely proportional to the input voltage is

introduced.

While in PWM (Pulse Width Modulation) mode, the output voltage is regulated by switching at a constant

frequency and then modulating the energy per cycle to control power to the load. At the beginning of each clock

cycle the PFET switch is turned on and the inductor current ramps up until the comparator trips and the control

logic turns off the switch. The current limit comparator can also turn off the switch in case the current limit of the

PFET is exceeded. Then the NFET switch is turned on and the inductor current ramps down. The next cycle is

initiated by the clock turning off the NFET and turning on the PFET.

Submit Documentation Feedback

Product Folder Links: LP3971

LP3971 датащи(PDF) 17 Page - Texas Instruments

LP3971 датащи(HTML) 17 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52

датащи скачать

ссылки URL