RV-3049 datasheet(35/65 Pages) MICROCRYSTAL

35 / 65 page

Micro Crystal

DTCXO Temperature Compensated Real Time Clock / Calendar Module

RV-3049

35/65

4.7. WATCH ENABLE FUNCTION

The function Watch Enable function “WE” (bit 0 in register Control_1) enables / disables the 1 Hz clock for the

watch function. After power-up reset, the bit “WE” is automatically set = “1” and the 1 Hz clock is enabled.

Setting “WE” = “0” stops the watch-function and the time circuits can be set and will not increment until the stop is

released. Setting “WE” = “1” allows for accurate start of the time circuits triggered by an external event.

“WE” will not affect the clock outputs at CLKOUT.

4.8. SELF-RECOVERY SYSTEM

The purpose of the Self-Recovery System is to automatically generate an internal Reset in case the on-chip state

machine goes into a deadlock. A possible source for such a deadlock could be disturbed electrical environment like

EMC problem, disturbed power supply or any kind of communication issues on the SPI interface.

The function of the Self-Recovery System is based on internal counter that is periodically reset by the Control

Logic. If the counter is not reset in time, a Self-Recovery Reset will be executed, at the latest after 2 thermometer

scanning interval periods, i.e. 2 or 32 seconds.

The Self-Recovery System is enabled / disabled by “SROn ” (bit 4 in register Control_1), it is automatically enabled

“SROn” = “1” after power-up by the register reset values, see section 4.2.2. REGISTER RESET VALUES.

Thermometer scanning interval is defined with “ThP” (bit 0 in register EEPROM_Control).

Generation of Interrupts from the System Reset function is enabled via “SRIE” = “1” (bit 4 in register Control_INT).

If “SRIE” is enabled, the INT follows the condition of Flag “SRF” (bit 4 in register Control_INT Flag). To clear

Interrupt signal ( INT ), both corresponding flags “SRF” (bit 4 in register Control_INT Flag) and “SR” (bit 4 in register

Control_Status) need to be cleared by writing = “0”.

During Self-Recovery or System Reset, the internal logic is reset and registers are loaded with the Register Reset

Values shown in section 4.2.2., Watch / Alarm and Timer information are not affected.

After Self-Recovery Reset, “SRF” is set = “1” (bit 4 in Register Control_INT Flag), indicating that an automatic

Self-Recovery System Reset has been executed.

RV-3049 датащи(PDF) 35 Page - MICORO CRYSTAL SWITZERLAND